Buttonhole Foot - Silvercrest SNM 33 A1 Instruction Manual

a b
e

Buttonhole foot

Preparation:
Remove the zigzag foot and attach the buttonhole foot.
Adjust the stitch length dial between "0.5" - "1". The
density of the stitch depends on thickness of the fabric.
Note:
To prepare the fabric:
Measure the diameter of the button and add 0.3cm (1/8")
for the bartacks. If you have a very thick button, add
more to the diameter measurement. Mark the position
and length of the buttonhole on the fabric.
Position the fabric so that the needle is on the mark that
is furthest from you.
Pull the buttonhole foot towards you as far as it will go.
Lower the foot.
a. Turn the pattern selector dial to "
c d
b. Turn the pattern selector dial to "
c. Turn the pattern selector dial to "
d. Turn the pattern selector dial to "
Remove the fabric from under the foot. Draw the upper
thread through the backside of the fabric and knot upper
and lower threads. Cut the center of the buttonhole with
the seam ripper, being careful not to cut the stitches on
either side.
Tips:
- Slightly reduce upper thread tension to produce better
- Use backing material for fine and stretchy fabrics.
- It is advisable to use a gimp cord for stretch or knit
Stitch
Always test sew a buttonhole.
moderate speed until you reach the end mark.
bartack stitches.
side of the buttonhole to the mark at the end which is
further from you.
tack stitches.
results.
fabrics. The zigzag should sew over the gimp. (e)
14
Silver Crest SNM 33 A1
Stitch width Stitch length
5 0.5~1
". Sew at
" and sew 5-6
" and sew the left
" and sew bar