Husqvarna 325 LX Operator's Manual page 2

325 LX Clean Sweep Assembly
Drum
Assembly
1. Push one of the drum axles onto
either of the two gearcase output
shafts. If necessary, rotate the
drum axle until the clevis pin hole
in the axle aligns with the matching
hole in the gearcase output shaft.
2. Use a clevis pin and hitch pin to
secure the drum axle to the shaft.
3. Slide the recessed end of a sweeper
drum assembly over the assembled
axle, and then push the drum down
the axle until it bottoms at the
clevis pin.
CAUTION!
The two drum assemblies are
identical, but each drum must be
installed with its recessed end
facing toward the gearcase.
Secure the drum axle
2
to the shaft
27033
Drum Axle
Cotter Pin
4. Use a cotter pin to secure the drum
5. Repeat Steps 1-4 to install the
2
Clevis Pin
Hitch
Pin
4
Secure
with a
cotter pin
Install the sweeper
3
drum assembly
assembly on the axle (see inset).
The cotter pin is designed to fit
tightly against the outboard end of
the drum, so you may need to
compress the drum face slightly
during installation.
remaining axle and drum assembly.
Install drum
1
axle onto
output shaft