NTI VEEMUX SM-nXm-C5AV-1000 Installation And Operation Manual page 47

NTI VEEMUX AUDIO VIDEO MATRIX SWITCH VIA CAT5
Example of using Outputs Scanning Sequences
Problem: A synchronous scan is desired for all outputs with a dwell time of 3 minutes per input, and no two outputs should be
looking at the same input at any given time.
Solution:
1. Set the dwell time for all inputs listed in each output at 180 seconds (3 minutes). Press "Save" each time changes are
made to the selected output. .
2. Go to the Video Switch page (page 18) and set each output to an input of the same number (1 to 1, 2 to 2, 3 to 3, etc..).
Click on "Submit" at the bottom of the Video Switch Page to submit selections and establish a connection and starting
point for the scanning sequence. (Blocks shown in yellow in the third image indicate connections made.)
3. Click on the "Sequence Enable" box for each output (from the Video Switch Page).
4. Click on "Submit" again to begin the scanning sequence for each output.
From the moment the configuration is submitted, a synchronous scan will begin on all outputs. Each output will connect to its
respective input for 3 minutes.
for 3 minutes. This cycle will continue indefinitely until sequencing is disabled.
Step 4- Click on "Submit" to begin
After 3 minutes, the outputs will each switch to the next consecutive input and remain connected
Step 1- setup dwell times
Step 2- setup starting point for scan and click "Submit"
Step 3- enable scanning sequences and click "Submit"
42