Siemens SIMpad SL4 User Manual page 90

Appendix
Internet connection
via PC card cannot
be established.
Internet connection
via cell phone cannot
be established.
Printing does not
work.
Data backup to the
PC does not work.
Error Message:
Low Memory.
Graphic attached to
an e-mail cannot be
displayed.
Taskbar can no
longer be called up.
90
If there are problems with the connection, remove
the PC card and re-insert it. Wait approximately 30
seconds. This is also needed to force a new
address enquiry on the I-Gate PC card (to switch
from a private network to a corporate network or
vice versa).
Ensure that the cell phone you are using has a
built-in modem.
Ensure that the Infrared function is switched on
on the cell phone (can be enabled/disabled in the
cell phone's settings).
Ensure that a serial cable connection or an
infrared connection exists between SIMpad and
the cell phone (see Page 47). With infrared
connections make sure that SIMpad and the
mobile are not more than 0.5 m from another and
that the two infrared diodes are at a maximum
angle of 15°.
Ensure that the cell phone is switched on and that
the battery capacity and network connection are
adequate (no radio gap, prepaid card not expired).
Ensure that the printer has an infrared interface
and that it is switched on (see Page 88).
With infrared connection make sure that SIMpad
and the printer are not more than 0.5 m from
another and that the two infrared diodes are at a
maximum angle of 15°.
Ensure that the data connection to your PC is
established (see Page 85).
Ensure that the ActiveSync software is installed
and started on the PC.
Close all open programs. Then reset the memory
partitioning (see Page 70). Increase the program
memory by approx. 2000-3000 KB (move the
slide to the left). Delete unnecessary files.
Increase the program memory (see Page 70).
Most graphics attached to e-mails are in JPG
format. For these graphics to be displayed on the
screen they have to be decompressed and stored
in the working memory. Sufficient free memory
must be available.
The taskbar Auto hide function is activated and
the screen is not properly calibrated. In this case,
switch on the input panel, tap the Ctrl key and
then press the left control key.