Configuring Gvrp On A Switch - HP ProCurve Series 2810 Management And Configuration Manual

4. Determine security boundaries and how the individual ports in the seg-
ment will handle dynamic VLAN advertisements. (See table 3-1 on page
3-7 and table 3-2 on page 3-8.)
5. Enable GVRP on all devices you want to use with dynamic VLANs and
configure the appropriate "Unknown VLAN" parameter (Learn, Block, or
Disable) for each port.
6. Configure the static VLANs on the switch(es) where they are needed,
along with the per-VLAN parameters (Tagged, Untagged, Auto, and Forbid—
see table 3-2 on page 3-8) on each port.
7. Dynamic VLANs will then appear automatically, according to the config-
uration options you have chosen.
8. Convert dynamic VLANs to static VLANs where you want dynamic VLANs
to become permanent.

Configuring GVRP On a Switch

The procedures in this section describe how to:
■ View the GVRP configuration on a switch
Enable and disable GVRP on a switch
■
■ Specify how individual ports will handle advertisements
To view or configure static VLANs for GVRP operation, refer to "Per-Port Static
VLAN Configuration Options" on page 2-8.
GVRP
Introduction
3-11