White And Black Balance Adjustment - Hitachi DK-H100 Operating Instructions Manual

White and black balance adjustment

White balance adjustment
White balance will be adjusted to the best effort in the sequence of AWB (auto white balance), ABB (auto
black balance), and again AWB.
Readjustment is normally not required even at power off/on.
Be sure to adjust the white balance after changes in the lighting conditions.
White and black balance adjustment progress can be observed from the screen.
Adjustment
1. Set the W.BAL MODE in the WHITE GAIN menu to MEMORY.
2. Set the FILTER with lighting condition accordingly.
See Optical filter selection in page 7.
3. Place a white pattern at a location subject to the
same lighting conditions as the scene. Use zoom
function of the lens so that the screen is white.
A white object (e.g., cloth, wall) placed near the scene
of interest can be used provided the size is adequate
(see figure).
4. Adjust the lens iris.
5. Hold the L button depressed for two second. White
balance is adjusted automatically.
6. During adjustment, the following messages appear on the screen.
7. Adjustment is completed in several seconds.
Adjustment in progress
White
cloth
Adjustment complete
8
At least 1/5 the screen width
At least 1/5 the screen height
< Note >
Use care a high luminosity
light source, such as a
spotlight, does not enter the
screen area.