CARING FOR YOUR POOL HEATER ----------------------------------- 15 In general, compared to other types of pool heaters such as gas or oil fired, the Waterco pool heater has a lower heating capacity on a kW/ hr basis. Therefore, it will be required to operate longer to accomplish the desired TROUBLESHOOTING ------------------------------------------------------- 17 results.
Dealer Phone _____________________________________ To find detailed product information, the location of the nearest Waterco dealer or to register your heater online, please visit our website at www.waterco.com Keep this book and the sales slip together in a safe place for future reference.
I pg 05 Heat Pump Swimming Pool Heaters WARNING DO NOT DEPRIVE HEATER OF WATER FLOW FOR MORE THAN 24 HOURS WITHOUT DRAINING IT. Make All electrical connections must be done by a qualified electrician, according to the local electrical codes. Always cut off the unit’s main power whenever the access panel is open or removed.
VITAL IMPORTANT Waterco models discharges air either from the top of the unit. Air is pulled through the evaporator coil and discharge through the grille. Clearance should be allowed in front and around the unit for unrestricted air discharge and service access. See Figure 1.
I pg 09 Heat Pump Swimming Pool Heaters Electrical Flow Check Valve IMPORTANT This is concerned with the installation of heat pumps below the pool water level. The heat pump operates on a pressure switch that activates the unit when the pool pump is switched on.
I pg 11 Heat Pump Swimming Pool Heaters GETTING TO KNOW YOUR POOL HEATER Bonding VITAL Operation of Square Electronic Control Because all metals have different electrical potentials, ALL metal and electrical components of the pool system MUST be bonded together. This includes the metal framework of the pool, the light, the pump, the filter (if metal), the heater, any automatic chlorine generator, and any other metal or electrical equipment.
I pg 13 Heat Pump Swimming Pool Heaters Initial Heating Temperature Differential The speed of heating is dependent upon five basic factors: It is possible for a temperature variation to occur between the probe and the pool thermostat measurement, due the quality of the pool thermostat .i.e., the value displayed is different from the temperature displayed on the pool...
They are usually the cause of this condition. The Waterco unit also has a built-in water pressure switch that will interrupt the operation of your unit should water circulation through the unit stop. If there is still a demand for heat, turn on your pool pump and the heater Usage Of Chemical Products will start up once the normal water flow is re-established.
1.0 to 4.0 PPM TOTAL ALKALINITY 100 to 120 PPM running for over 5 hours. If water is still coming out of your heater after this period you should call Waterco IS IT POOL CLOSING TOTAL DISSOLVED SOLIDS below 1800 Reg. Pool for service.
(it makes no difference in which way the blue and white wires are plugged in) Service can be obtained by calling us at 1-450-796-4333 or by Internet at www.waterco.com. When asking for help or service, please provide a detailed description of the problem, your heater’s model and Rubber Grommet serial number, and the purchase date.
G. Parts or Heater transportation to our office. Waterco International Inc. will replace or repair, at its choice, all defective part provided that this part is sent prepaid to our factory during the warranty period. Parts returned during the warranty period will be repaired or replaced and returned prepaid within Canada, Australia and New Zealand by the best and most economic means of transportation.
Need help?
Do you have a question about the HEAT PUMP SWIMMING POOL HEATERS and is the answer not in the manual?
Questions and answers