Table of Contents
Advertisement
1
PLACEMENT OF THE MOUNTING PLATE
.
REMOVING THE MICROWAVE
A
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
Remove the installation instructions, filters, glass
1
tray, and the small hardware bag. Do not remove
the Styrofoam protecting the front of the oven.
Fold back all 4 carton flaps fully against carton
2
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.
Styrofoam
Pull the carton up and off the oven.
3
Remove and properly discard plastic bags.
4
Screws
Remove the 2 screws from the mounting plate.
5
This plate will be used as the rear wall template
and for mounting. You may discard these screws.
Installation Instructions
Carton
Mounting
Plate
.
B
FINDING THE WALL STUDS
Wall
Studs
Center
Find the studs, using one of the following
1
methods:
A. Stud finder – a magnetic device which
locates nails.
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
After locating the stud(s), find the center by
2
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16" or 24" from this mark.
Draw a line down the center of the studs.
3
THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
8
OR
Hide quick links:
Advertisement
Table of Contents
