Related Manuals for Piranha CZ-901
Summary of Contents for Piranha CZ-901
- Page 1 Steam Mop User Manual Model No.: CZ-901 Item No. 900127 Rev 2 READ AND SAVE THESE INSTRUCTIONS Note: The specifications and/or components of this appliance are subject to change without prior notice...
-
Page 2: Table Of Contents
Warnings .................. 3 Safety Direction ............... 3 Transporting your Steam Mop ..........4 Specification ................5 Components ................5 Assembly ................. 6 Micro Fibre Pad ............... 7 Operation ................. 8 Using on carpets ..............9 Water Filter ................10 User Maintenance .............. 10 10.1 Cleaning the Micro Fibre Pads .......... -
Page 3: Warnings
Warnings Before using this appliance, read and follow all warnings and instructions in this manual, even if you are familiar with this product. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. -
Page 4: Transporting Your Steam Mop
It is highly recommended to disconnect the plug from wall socket and let cool before changing the micro fibre cleaning pad. This appliance must be earthed. The use of an Earth Leakage Safety Switch is highly recommended. Refer to your electrician for further information. This product can be used for cleaning floor surfaces such as sealed wooden floors, ceramic tiles, granite and marble flooring, including some types of carpet. -
Page 5: Specification
Specification Supply: 220 - 240Va.c. 50Hz Rated Power: 1500W Tank Capacity: 750ml Components Handle On / Off Trigger Cord Wind Hook Carry Handle Water Tank Water Fill Cap Water Filter Main Body Indicator Light Floor Head Micro Fibre Pad Page 5 of 12... -
Page 6: Assembly
Assembly A small amount of assembly is required when you receive your steam mop. You will need a Philips Head Screwdriver. • First, remove all the components from the packaging. • Take the Handle and fit it into the hole located in the top of the Steam Mop body. -
Page 7: Micro Fibre Pad
• Fit the Short Screw into the hole on the back of the Steam Mop neck and screw in tight Micro Fibre Pad • To fit the Micro Fibre Pad, place the Micro Fibre Pad on the floor with the fibre side facing out. -
Page 8: Operation
Operation Note: Ensure the Micro Fibre Pad is fitted before use. • After fitting the Micro Fibre Pad, lay the steam mop down on its back. • Remove the water tank by sliding it towards the handle then lift up. •... -
Page 9: Using On Carpets
• At this time, start to push and pull the Steam Mop over the floor as if you are vacuuming the floor. • If you need to stop cleaning the floor i.e. you need to move an object, or the phone rings, and steam is still being ejected from the base, press the Trigger on the handle to turn off the pump and element. -
Page 10: Water Filter
Water Filter This appliance is fitted with a water filter to filter out and large particles which could block the steam jet. This filter needs to be replaced once a year or more often depending on your water quality. • To remove the filter, first remove the water tank as described under “Operation”. -
Page 11: Cleaning The Steam Mop
10.2 Cleaning the Steam Mop Do not clean the Steam Mop or components with petrol or any other flammable liquids, solvents, etc. Use only a moist cloth and mild detergent for cleaning the Steam Mop. Clean only the outside of the Steam Mop. After cleaning, wipe off the moisture with a dry cloth. -
Page 12: Warranty Against Defect
Warranty Against Defect WHAT’S COVERED? 5.2 Our goods come with guarantees that cannot be excluded under Australian Consumer Law. You H.E. Group Pty Ltd (“us” “we” or “our”) are entitled to a replacement or refund for a warrants this good for a full replacement or major failure and compensation for any other refund for a period of twelve months from reasonably foreseeable loss or damage.
Need help?
Do you have a question about the CZ-901 and is the answer not in the manual?
Questions and answers