On/Off/Night Switch - Bunn IMIX Service & Repair Manual

SERVICE (cont.)

ON/OFF/NIGHT SWITCH

FIG. 36 ON/OFF/NIGHT SWITCH
Location:
The ON/OFF/NIGHT Switch is located inside the
dispenser door on the lower right side of the whipper
panel.
Test Procedures:
1. Disconnect the dispenser from the power source.
2. Disconnect the wires from the switch terminals.
3. Check for continuity between the center terminal
and upper terminal with switch in the NIGHT (lower)
position. Check for continuity between the center
terminal and the lower terminal with the switch
in the ON (upper) position. Continuity must not
be present when the switch is in the OFF (center)
position.
If continuity is present as described, the switch is
operating properly.
If continuity is not present as described, replace the
switch.
Removal and Replacement:
1. Remove all wires from the switch terminals.
2. Compress the clipson the switch and gently push
the switch through the opening in the panel.
3. Push the new switch into the opening of the panel
so that the clips snap it securely into place.
4. Refer to Fig. 37 when reconnecting the wires.
P1637
34
FIG. 37 ON/OFF/NIGHT
SWITCH TERMINALS
P1800
42032 060109