Setting Up the Amplifier with a Computer
The amplifier can be set up using a computer with an LCI software kit, or a
handheld terminal.
Before setting up with a computer, ensure that the LCI software kit has been
installed on your computer. For detailed information about the software installation
and requirements, see LCI Software Installation Instructions, part number 4033113.
Operation
To set up the amplifier via the LCI software, you must connect the amplifier either to
a USB port with an LCI-USB cable or to a serial port. Follow the steps below to set up
the amplifier:
1. Start the LCI software.
Result: An LCI Detect Configuration window appears.
Note: If you use a serial port on the computer, type the desired serial port name into
the COM Port box such as COM1.
2. Click Node Products, and then Click Start to find the amplifier.
Result: A Refresh dialog box appears.
3. Click OK to finish.
4. Double-click the amplifier in the left tree to display the amplifier configuration
window.
4038501 Rev C
Operation
Continued on next page
3-3