User Manual Directional Passive-Infrared Sensor SIP-1201DD Important Safety Instructions Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings, Install in accordance with the manufacturer’s instructions.
Page 2
Use only with the cart, stand, tripod, bracket, or table specifi ed by the manufacturer, or sold with the apparatus. When a cart is used. Use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lighting storms or when unused for long periods of time.
EXPLANATION OF GRAPHICAL SYMBOLS The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
Page 4
Please read the following recommend safety precautions carefully. Do not Place this apparatus on an uneven surface. Do not install on a surface where it is exposed to direct sunlight, near heating equipment or heavy cold area. Do not place this apparatus near. Do not attempt to service this apparatus yourself.
IR Sensor at a Glance Body Sensor Housing Cover Alarm LED Spare LED LENS Rear Front Display the scanning direction Internal Status LED Alarm LED Direction Switch DIP Switch Tamper Switch Terminal OUTPUT Select Switch Wiring Hole LED Select Switch What’s Included User Manual/ Screw (x2)
Installation Ceiling Mount Turn the cover left to loosen it from the body. Turn the screws (4x25) clockwise to secure the body to the ceiling and do the wiring as necessary. Adjust the lens in full detail to set the boundary scanning range.
Page 7
Setting the direction switch If intrusion is made in the arrow direction, set the pin to the left or right accordingly. For an apartment building, intrusion is made from the porch to the living room. If you turn off the switch #3, the directional detection will be disabled.
Page 8
Setting the output contact point with the terminals Setting OUTPUT Scanning: Scanning: Connected Turns off Alarming: Alarming: Disconnected Turns on Factory Default Scanning: Scanning: Terminal Layout Disconnected Turns off Alarming: Alarming: Connected Turns off Terminal Description Comment +12V Nonpolar COMMON Output jumper pin setting N.C/N.O TAM1...
Specifi cations & Appearance Specifi cations Item Description Scanning Type Directional Detection & Duplex Area Scanning Scanning Range Voltage and Current DC 12V (±15%) / 19mA Consumption Number of Sensing 16 zones Zones Height 1.8m ~ 3.0m (basis of 2.6m) Sensing Speed Min.
Page 10
Correct Disposal of This Product (Waste Electrical & Electronic Equipment) (Applicable in the European Union and other European countries with separate collection systems) This marking on the product, accessories or literature indicates that the product and its electronic accessories (e.g. charger, headset, USB cable) should not be disposed of with other household waste at the end of their working life.