Fujitsu s3-0801 User Manual page 22

3. Local Port Operation
6. Click OK to save settings.
-or-
Click X to exit without saving changes.
Setting the keyboard country code
Using a keyboard code that supports a language different from that of your switch
firmware will cause incorrect keyboard mapping.
Sun servers may use keyboard mappings for non-US keyboards. By default, the
s3-0801/1601 switch sends the US keyboard country code to Sun and USB
modules attached to target devices, and the code is applied to the target devices
when they are turned on or rebooted. Codes are then stored in the IQ module.
Issues may arise when you use the US keyboard country code with a keyboard of
another country. For example, the Z key on a US keyboard is in the same location
as the Y key on a German keyboard. Sun servers will interpret pressing the Y key
on a German keyboard as pressing the Z key when the US keyboard country
code is used.
The Keyboard dialog box enables you to send a different keyboard country code
than the default US setting. The specified country code is sent to all target
devices attached to the switches when they are turned on or rebooted, and the
new code is stored in the IQ module.
If an IQ module is moved to a different target device, the keyboard country code will
need to be reset.
See "Sun Advanced Key Emulation" on page 47 for information on emulating
certain Sun keys using a PS/2 keyboard and special considerations for Japanese
and Korean Sun USB keyboards.
To set the keyboard country code for Sun servers:
1. Activate the OSD and click Setup - Keyboard to open the Keyboard dialog
box.
2. Select a country code and click OK to save your settings.
3. Reboot the Sun servers. After rebooting, each Sun server will request the
country code setting stored in the IQ module.
If you wish to reboot the target devices by power-cycling them, you must wait 90
seconds before rebooting. A soft reboot may be performed without waiting 90 seconds.
16
590-1035-640A