Technical Data; Installation - Electrolux ESL 67040 User Manual

18 electrolux

TECHNICAL DATA

Dimensions
Electrical connection
Water supply pressure
Capacity

INSTALLATION

There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
Caution! Instructions for the
installation, the furniture door and the
water connection are in the separate
template that is provided with this
appliance. Follow carefully these
instructions.
Warning! Make sure that the mains
plug is disconnected from the mains
socket during installation.
Warning! To prevent injury or damage,
make sure that the appliance is under
and adjacent safe structures. Use the
supplied brackets to attach the
Width
Height
Depth
Voltage
Overall power
Fuse
Frequency
min.
max.
Place settings
The hose s hould not be
extended by more than
2 metres or water pump-
out problems ma y occu r
Secure dishwasher with
brackets and screws provided
Gap on both sides should be
equal, & no greater than
5 mm per side.
• K ickplate fixing screws
If floor is not level, adjust
levellin g legs to suit
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
600 mm max.
300 mm min.
•
appliance under the kitchen counter or
to the adjacent units.
Install the appliance under a kitchen coun-
ter.
If a repair is necessary, the appliance must
be easily accessible for the engineer.
Put the appliance adjacent to a water tap
and drain.
For the venting of the appliance only water
hoses and mains cable openings are nec-
essary.
The appliance has adjustable feet to allow
the adjustment of its height.
596 mm
818 - 898 mm
550 mm
220-240 V
2200 W
10 A
50 Hz
50 kPa (7 psi)
800 kPa (116 psi)
13