Tool Shop 10” 15 AMP COMPOUND MITER SAW Operator's Manual page 8

E.) Dust bag (Fig. 2, 6, & 9)
The saw is equipped with a sawdust bag (13) to
collect sawdust and chips. You can release the
sawdust bag (13) from the sawdust exhaust port (33)
by pressing together on the two clips. To empty the
bag, unzip at the bottom.
F.) Replacing the saw blade (Fig. 1,7, & 9 )
Remove the power cord from the power
outlet!
• Raise the machine head (4) to top position.
• Unscrew the Blade Cover Plate screws (34) and flip
the cover plate up together with the saw blade guard
(6).
• Press the blade lock (1) with one hand while
holding the Phillips headed hex wrentch (25) on the
flange bolt (not pictured) with the other.
• Firmly press on the blade lock (1) and slowly rotate
the flange bolt (not pictured) in clockwise direction.
The blade lock (1) engages after no more than one
rotation.
• Now, using a little more force, loosen the flange
bolt (not pictured) in clockwise direction.
• Turn the flange bolt (not pictured) until it is
completely removed.
• Take the saw blade (5) off the inner flange and pull
out downwards.
• Mount the new saw blade (5) in reverse order and
fasten.
Important!
The cutting bevel of the teeth, i.e. the
direction of rotation of the saw blade (5), has to conform
with the direction of the arrow marked on the housing.
• Clean the saw blade flanges thoroughly before
mounting the replacement saw blade (5).
• Reattach the movable blade guard (6) In reverse
order.
• Before using the saw again, check that the safety
devices are in good working order.
Important!
Every time that you change the saw blade (5),
check to see that it spins freely in the groove of the
turntable in both perpendicular and 45° angle settings.
Figure 6
34
13
11
23 9
Figure 7
3
4
34
4
5
17
8
14
27
19 26
5 6
2
34
6
10
2