Turn The Radio On Or Off; Using The Etm (Easy Tuning Mode) To Listen Radio - Tecsun PL-380 Operation Manual

3. To stop auto search memory, simply press [VM] button.

TURN THE RADIO ON OR OFF

1. Installing batteries
The battery compartment is located on the back of the PL-380. To remove the battery
compartment cover, apply thumb pressure and slide it towards the bottom of the radio.
Install 3 AA alkaline batteries into the battery compartment, observing the battery
polarity diagram on the back of the radio. Display screen would show battery capacity,
time, etc.
2. Short press on [POWER] button to turn the radio on or off.
Note: If the radio is not able to be turned on. Please check if the batteries were
installed correctly, battery capacity is sufficient or the lock function had been applied with
symbol "key" displayed on screen.
Listen to the radio
Short press [POWER] button to turn on your radio, and select your band by short press on
[FM]、[MW/LW]、SW[
antenna should be pulled out as long as possible and adjust the volume level. Now, turn in
your favorite station with either one of the following methods:
Method 1: Using the ETM (Easy Tuning Mode) to listen radio
1.) Press & release the [ETM] button with 1 beep sound followed to switch into ETM
status.
2.) Press & hold [ETM] button with 1 "B" sound followed. It means frequencies of radio
stations in this band would be selected. The ETM operation would be finished with 1
long "B" sound followed.
Important descriptions for ETM (Easy Tuning Mode) :
1.) If ETM (Easy Tuning Mode) is used, you could easy adjust to your favorite radio from
the prior selected radio frequency.
www.tecsunradio.com
] or [ ] button. In case of receiving FM/ SW, telescopic
hch@cantonmade.com