Table of Contents
Advertisement
OWNER'S MANUAL
1200 W CLASS-D MONOBLOCK SUBWOOFER AMPLIFIER
Thank you for purchasing a JL Audio amplifier
for your automotive sound system.
Your amplifier has been designed and manufactured to exacting
standards in order to ensure years of musical enjoyment in your
vehicle. For maximum performance and extended warranty
coverage, we highly recommend that you have your new amplifier
installed by an authorized JL Audio dealer. Your authorized
dealer has the training, expertise and installation equipment
to ensure optimum performance from this product. Should you
decide to install the amplifier yourself, please take the time
to read this manual thoroughly so as to familiarize yourself
with its installation requirements and setup procedures.
If you have any questions regarding the instructions in this
manual or any aspect of your amplifier's operation, please
contact your authorized JL Audio dealer for assistance. If you
need further assistance, please call the JL Audio Technical
Support Department at (954) 443-1100 during business hours.
Advertisement
Table of Contents
Related Manuals for JL Audio 1200/1V3
Summary of Contents for JL Audio 1200/1V3
- Page 1 OWNER’S MANUAL 1200 W CLASS-D MONOBLOCK SUBWOOFER AMPLIFIER Thank you for purchasing a JL Audio amplifier for your automotive sound system. Your amplifier has been designed and manufactured to exacting standards in order to ensure years of musical enjoyment in your vehicle.
-
Page 2: Protect Your Hearing
Cutoff Frequency Filter Cutoff Defeat Switch Remote Bass Filter Frequency for Input Jacks (pg. 9) (pg. 10) Frequency (pg. 9) Control Knob Amplifier Channel (pg. 7) (pg. 10) (pg. 10) (pg. 8) 2 | JL Audio - 1200/1 Owner’s Manual... -
Page 3: Product Description
13) Turn on the source unit at a low level grommet to prevent damage to the insulation If only the 1200/1v3 is being run from that operation. 2 AWG or larger is recommended to double-check that the amplifier is of the wire. -
Page 4: Remote Turn-On
1200 /1 AWG pure copper wire (or larger) when the 1200/1v3. You may run a stereo or a mono wires of the source unit or small amplifier Monoblock Subwoofer Amplifier installing amplifier systems with main fuse signal into the inputs of the amplifier. -
Page 5: Crossover Controls
2) “Amp Filter”: The preamp output delivers the level of the amplifier by adjusting the speakers in the system. Experiment to find the same signal that is feeding the 1200/1v3’s input sensitivity downward, if the amplifier the slope which best matches the acoustic... -
Page 6: Subwoofer Output
Mode all signal from flowing through the circuit. If you connect a load higher than 4Ω nominal to the 1200/1v3, power will drop by half with 2) Parametric Bass Equalizer: The parametric every doubling of impedance above 4Ω. If you connect a load lower than 1.5Ω... - Page 7 Keep in mind that any large amplifier, like amplifier, seating them firmly so that no bare the 1200/1v3, places a very heavy demand on a wire is exposed. While holding each wire in place, 1) Power (Green): lights to indicate that the vehicle’s charging system when operated at its...
- Page 8 (within the frequency Input Section: design is beneficial for many reasons. One of range to be amplified by the 1200/1v3) at 3/4 Input Type: Differential-balanced with RCA jack inputs these reasons is ease of setup. Because each source unit volume.
- Page 9 39 ......198 Full-clockwise : 197 Full-clockwise : 61 Full-clockwise : 81 Full-clockwise : 198 16 | JL Audio - 1200/1 Owner’s Manual...
- Page 10 1200/1v3, it properly calibrate the amplifiers for Range Output Mode is possible to connect multiple 1200/1v3’s in a Output Mode maximum, identical, clean output, please Amp Filter refer to Appendix A (page 14). After using this...
-
Page 11: Appendix E: Trouble Shooting
Check the nominal load impedance to verify that the amplifier (between 200mV and 8.0-volts) should be present at the is driving a load between 1.5 - 4Ω. JL Audio monoblock output of the signal cables. amplifiers have two “+” positive connections and two “–”... -
Page 12: Installation Notes
Advanced Bass MONO OUTPUT ONLY Control LP | HP Off | On Left Output Right Output Filter Freq. (Hz) Infrasonic Freq. (Hz) Remote Bass Port Filter Freq. (Hz) Left Ch. Right Ch. 22 | JL Audio - 1200/1 Owner’s Manual... - Page 13 LIMITED WARRANTY - AMPLIFIERS (USA) JL Audio dealer using a JL Audio Premium Power Connection System for power wiring. accident, misuse, abuse, product modification or neglect, failure to follow installation instructions, or consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear and tear is not covered under warranty.
Need help?
Do you have a question about the 1200/1V3 and is the answer not in the manual?
Questions and answers