Do you have a question about the EDB-2 and is the answer not in the manual?
Questions and answers
Summary of Contents for headway EDB-2
Page 1
Suitable for stage and other signal processing. EDB-2 offers an increased range of gain to interface better with Mixers, luxurious amounts of EQ and other highly versatile facilities to get the best possible sound from amplified acoustic stringed instruments.
Page 2
From a single compact box, the EDB-2 can take on a unique range of functions and qualities which include: • Refined Class "A" inputs and Pro Audio IC components. • Voiced for warmth, clarity & low noise Now offering increased clarity and even lower noise.
Page 3
• Sturdy steel housing with quality pots and long life sockets. • Choice of input and output connectors. Congratulations on your astute purchase. Please read this comprehensive manual carefully before switching on or plugging in the EDB-2 Text is also available on website below: www.headwaymusicaudio.com Headway Quality! Built to last &...
Page 4
HEADWAY EDB‐2 Top Panel LOW BATTERY LED EARTH/GROUND LIFT POWER ON/OFF/STANDBY Lights BLUE when Prevents Hum Loop by Green LED Ba eries are within Disconnec ng Pin 1 from Indicates Power hours of expiring XLR OUT Pause in Standby Posi on to Reduce Power on “Thump” MASTER Sets Output Level to LINE OUT & XLR Out NOTCH FILTER ‐12dB Notch Q=Band width Freq. = Centre Frequency of cut. MUTE Switches : CH.1 CH.2 or Turns OFF Output Signals Re. Red LED. LIVE Denotes Pre‐Amp Output ON ...
Page 5
Post EQ to Master Vol. OPTIONS Belt Clip (as shown) or EDB‐2 Front Panel Mic Stand Adaptor 19/32” (15mm) CH.1 JACK IN CH.2 MONO JACK IN CH.2 MIC/XLR IN PHANTOM POWER Mono IN Routes Stereo to Both Balanced with TO CH. 1 (Refer to Input Impedance Channels if No Jack in CH.1 18v Phantom JACK IN SWITCH Switch & Phantom Power Power Op on. Switch) See XLR Switch: XLR Off/On Phantom On EDB‐2 Rear Panel DI/XLR LINE OUT BATTERY PANEL Balanced Line (PP3/6F22 x 2) EXT. POWER IN Output XLR (Mono Mix) With Cap ve Screw 18v AC/DC Adapter Input Connector This does NOT accept Phantom Power Use ONLY Headway EDB‐PSU From Mixer* 5 ...
Equaliser Direct Blend unit very carefully: IMPORTANT: Make sure that you power only by Headway's supplied Power Supply Unit: Headway EDB PSU or via 2 x PP3 (9v) batteries as included with this unit. (Suitable for EDB-1 & EDM-1) Mains Plug Connector Types available for EDB-2: UK = United Kingdom/Eire/Singapore (e.g.
Page 8
Mic stand or Belt mounting. DO NOT BLOCK EXITS! 1.1.8 PRECAUTIONS DURING USE Treat your EDB-2 with care and do not drop it, tread on it or subject it to liquids, extreme heat/cold or rough handling.
Page 9
Music Audio Ltd. or its approved agents where applicable. All returns must be sent pre-paid and should be insured against loss. Headway Music Audio Ltd. will NOT be held responsible for losses in transit or for duty and taxes incurred, e.g. where customs documentation is completed incorrectly.
Page 10
1.7 WARRANTY/GUARANTEE TERMS EDB-2 guarantee is valid for up to, but no longer than 12 months from the date of purchase, but valid only after the guarantee registration has been made online at www.headwaymusicaudio.com All guarantee issues will be subject to assessment by Headway and appointed service agents where applicable.
Page 11
BEFORE THE 30 DAY PERIOD EXPIRES! 1.8 STORAGE & TRANSPORT ADVICE Headway Music Audio Ltd. suggest storing & transporting the EDB-2 in the complete original box or inside a heavy cardboard box in good condition. Always pad it out in order to prevent the unit from shifting in transit.
NON-Powered Pickups directly into EDB-2 The primary types of pickups include Piezo cable or Co-axial cable pickups (Headway HE4 Passive) or Flexible “Piezo Film” pickups as offered by a number of manufacturers. Most are flexible structure types but some film pickups are encased in rigid metal.
Page 13
3.1.3 ACTIVE/LOW: Impedance Input < 50k Ohm This input is optimised for active pickup systems which require battery power. It is also used for some Passive Magnetic/Low Impedance pickups but on passives there will be a treble roll-off and hence a thicker more middle biased sound.
Larger instruments such as Steel Strung Acoustic Guitars often require a mid range cut especially where full chords are played. Headway HE4 & Snake3 Fixed EQ pickups will require less EQ applied than most other pickups because they incorporate an active tone section which is set for the instrument type specified.
Page 15
BOOST EQ FACILITY: Boost functions only work effectively if there is sufficient of the frequency in order to be able to increase it. For critical applications, EQ is generally thought to sound better where cut rather than boosted. Most importantly with EQ is to use your ears! 3.2.1 BASS Control: +/- 12dB centred broadly @ 120Hz or +/- 16dB @ 45Hz Allows control of the bass at the lowest frequency of the audio spectrum and will over-lap a little tonally with LO MID control.
Page 16
Overall 5 Band EQ can be switched to both channels combined or to either channel separately. EDB-2 may operate a dual system by applying 5 Band EQ to one channel (or both channels) and notch filter to the other channel.
Page 17
Channel 1. For live performances when using Mics you should use Uni-directional Mics such as Cardiod and especially Hyper-Cardiod Polar Patterns. The EDB-2 was NOT primarily intended to be used for two totally separate sources such as Guitar + Vocals since you will normally require different settings of EQ.
Page 18
Mic holder. External Mics will still be very prone to feedback than most pickups but at least they should sound better than internal Mics. Headway's Co-axial Piezo Cable Under Saddle pickups offer a more natural sound than flat pickups since they sense around 360 degrees.
Headway Music Audio Ltd. will NOT accept requests for information on other manufacturers wiring or specifications. Headway Music Audio Ltd. will not be held liable for damage to other manufacturers pickup systems from Phantom Power. The Ring Position suits more typical pickup systems where wired for Phantom.
18v Phantom Power to XLR will operate most Condenser Mics at above minimum voltage requirements. To date only SE Mics have been identified as NOT operating. If powering Condenser Mics or other devices from EDB-2 note low battery LED. Powering Constraints: It is NOT possible to power the EDB-2 via Phantom Power from a Mixer.
Page 21
6.2 NOTCH Frequency Knob: 50Hz - 6kHz Sets the approximate centre frequency from 50 Hz (low bass) - 6kHz (treble) where notch cut applies. 6.3 Notch Filter Switches i) Slider Switch determines whether the notch filter is in or out. This enables you to determine whether you like the application on or off without altering settings.
7 MASTER VOLUME CONTROL Sets the output level of the EDB-2 preamp which is fed to the LINE OUT and DI Out sockets. Also applies as control to Aux. In. See 3.1.6: Gain &...
ii) Violin: Cuts bass and Low Mid frequencies significantly below 200 Hz. This setting also applies to similar smaller, high pitched instruments such as Mandolin and Ukulele. iii) Bass: Cuts gently below 40 Hz. This setting applies to all instruments producing bass such as Double Bass.
Low battery Indicator LED will glow BLUE when battery voltage is around 7.5v and battery is close to being exhausted. EDB-2 will fail within a few hours of use or when battery voltage falls below 7v each. 10 PHASE REVERSE – 3 Way Slider Switch: "Phase" Setting denotes IN Phase.
Page 25
11.2.2 CH. 2 INPUT Input Impedance to Jack via 3 Way Switch: +Hi = >20 Meg Ohms Hi = 5 Meg Ohms Active/Low Impedance = 1 Meg Ohms Post EQ/Routes to MASTER Vol. Input Impedance to XLR: 2kOhms Balanced. Gain Control to Jack: Continuously variable 0 - +32dB.
Page 26
11.2.7 PHANTOM POWER XLR Mic Input on Ch. 2: 18v with 6K8 Current Limit Resistors (Pins 2 & 3) Jack Socket Input on Ch.1: 9v with 10 mA Current Limit. 11.2.8 OUTPUTS Line Output via Jack: Nominal -10 dBu RMS @ 100 Ohms Mix of Ch.1 &...
Outer = +VE (Positive) /Inner = -VE (Negative) EDB-2 Input DC Plug Dimensions Centre Hole: 2.1mm Diam./Plug Diam: 5.5mm./Plug Length: 10mm Use ONLY Headway Music Audio Ltd. supplied EDB PSU as in 1.1 Headway will NOT honour guarantees where incorrect Power Supplies cause damage.
Page 28
Hyper-Cardiod, such as DPA. Contact pickups such as “The Band” (Bowed Instruments) to give an advantage over Mics on feedback rejection. Headway's active under saddle pickups in fretted instruments (HE4 & Snake3) or the VL3 Violin Bridge Pickup should offer much greater sound pressure levels before feedback.
Page 29
Getting people into an enclosed performance space will soak up a lot of sound reflections and discourage feedback as if MABS or Mobile Acoustic Baffles! Check that a power amp output is not plugged into EDB-2 inputs. 12.2 UNEVEN STRING AMPLIFICATION, HARSH or BOOMY SOUND Under saddle pickups may not be seated correctly and evenly in instrument.
Page 30
Use highly screened instrument cables, shorter, uncoiled cable runs and metal shielded jack covers with good solder connections. When using the XLR DI outputs on the EDB-2 set the GND LIFT button to cut earth loop hums if required. AC Mains Filters are useful to stop an impure mains power source affecting your amplifier.
It is recommended that you use the best quality connectors such as Neutrik, Deltron & Schurter/Rendar, Switchcraft, Horizon, ST Professional & GH. If EDB-2 has somehow become overheated, turn off, cool it down and try turning on a little later to re-start checking batteries & IN signals. 12.6 PERSISTENT PROBLEMS...
Page 32
EDM-1 Equaliser Direct Mini - Sub Compact EQ Pre-amp with comprehensive EQ and Range/Anti-feedback Control plus optional DI connector. EDB-2 Equaliser Direct Blend - Multi-Function Pre-Amplifier with EQ, Blend & DI functions for Superior Acoustic Amplification. Sheer Acoustic SA2 & SA2-B - Active Under Saddle Pickup System for Acoustic Guitar &...
Page 33
We recommend that to get the best possible sound you use only Headway Pickups and good quality true Condenser Mics such as the excellent DPA Miniature Instrument Mics. Find out more about Headway's other products from: Headway Music Audio Ltd.
Page 34
OTHER HEADWAY PRODUCTS INCLUDE: EDM‐1 Mini EQ Pre‐Amp/DI Box HE4 & SNAKE3 Under Saddle Ac ve Pickups THE BAND Instant fit Pickup for Violin, Viola, Cello & Double Bass 34 ...
Need help?
Do you have a question about the EDB-2 and is the answer not in the manual?
Questions and answers