This unit is the latest generation VoIP terminal product applied to the IP network for voice communication. The heaviest Characteristic of IP phone is that what transports voice over network at an extremely low cost with excellent sound quality. 1.2 Characteristic and compatibility Supports 2 10/100M Ethernet ports(one for WLAN,the other...
TCL-IP (8) User Manual Supports quick dial and redial functions Resetting function when the phone meets catastrophic problems Supports keypad、consoles port、Telnet and Web management modes 1.3 Standard and Protocol IEEE 802.3/802.3 u 10 Base-T/100Base-TX Supports G.711A/μ、G.726、G.729A/AB、G.723.1/A 、 G.722.1 audio codec...
TCL-IP (8) User Manual 1.4 Panel layout Panel planform and Rear panel Figure 1.1 TCL-IP8 Charts 1.5 Key Definition The function keys of the unit defined as below table1.1 Key Name Definition Press it to get the IP of the phone under standby status;...
Page 4
TCL-IP (8) User Manual respectively. In off state,press this key to browse and select Ring your personal rings. Redial In picking state, redial the number In off state, press this key to enter the setting-up Menu menu In setting state, press this key to 1.Enter into the modified state of present item...
TCL-IP (8) User Manual Pick up the receiver or press the hand free key, and then press the number keys to dial (each key corresponds with 123456789*0#) Number Keys In setting state, it is used to input IP address, port...
TCL-IP (8) User Manual Chapter 2 Phone setting The gift box of this unit packs the following parts: IP8 telephone set, adapter, connecting line, and the user’s manual etc. The fixing procedure: connecting this unit to network and the phone ports with the net-connecting line, and then connect the adapter with the power port of the unit.
Page 7
TCL-IP (8) User Manual Figure 2.1 HTTP login interface b、Key in User name and password as “admin” and “123456” to enter the setting interface (for normal user is “user”and “1234”), the following interface will display after entering successfully, then select the items on the left side to set the parameters.
TCL-IP (8) User Manual Figure 2.2 HTTP login interface Note: All the settings go into effect after restarting the phone. 2.1.1 Network Setting Figure 2.3 shows the network setting and the protocol setting pages respectively. You can set the IP address, the subnet IP, the gateway IP and the correlating items of the protocol through these pages.
Page 9
TCL-IP (8) User Manual Figure 2.3 Network setting interface TCL communication www.tclcomm.cn...
TCL-IP (8) User Manual 2.1.2 Protocol Setting The phone supports SIP protocol After finishing the network setting, enter “ protocol” interface (Figure2.4),all the parameters filled in the below form are provided by the ISP.Upon the completion of the network setting and the protocol setting, you need to restart your phone before using.the...
Page 11
TCL-IP (8) User Manual Figure 2.5 PPPoE configurations Figure 2.6 NAT setting TCL communication www.tclcomm.cn...
TCL-IP (8) User Manual 2.1.4 Voice setting Setting the AGC、AEC、codec and DTMF transmit mode in this menu,thereinto, VAD、AGC、AEC will be available after giving each them a tip which factory default is not available;and the default value of codec is “Auto”,at that time ,the phone...
TCL-IP (8) User Manual Figure 2.8 Time zone setting 2.1.6 Information view 2.1.6.1 version information The type of the protocol、software version and the release time information of the phone can be viewed in edition menu which is under“info display”column. Detaiedl info is as below Figure 2.9.
Page 14
TCL-IP (8) User Manual 2.1.6.3 Register information The register information of the phone can be viewed in the info display column. Figure 2.11 Register information 2.1.6.4 Communication record All the answered calls, missed calls, dialed numbers can be reviewed in the info display column.
Page 15
TCL-IP (8) User Manual 2.1.7 System tools 2.1.7.1 Default setting Click the “Factory default” to enter the factory default interface, click “restore”button to resume to factory default setting value.See as Figure 2.14 Figure 2.14 Restore to factory default setting interface 2.1.7.2 Software upgrading...
Page 16
TCL-IP (8) User Manual information and restarting the phone 2.1.7.3 Revise the administer password The phone supports two grades user to sign in the interface, using “admin” is as the administrator status, under which the user can reset all parameters in the interface, containing revises the passwords of usernames for admin and user;...
Page 17
TCL-IP (8) User Manual Figure 2.16 Copy configuration interface 2)then click the backup setting button the save the info(use .conf as postfix) 2.1.7.5 Update the configuration file Update the configuration file for the phone by using this item function. 1)Click “ restore setting ” menu , the following Figure2.17 will appear.
Page 18
TCL-IP (8) User Manual “missed calls”and “accepted calls”one by one; Press the “set”key prior to pressing ‘page up’ 、‘page down’ keys to play the “phone log” information, and user can dial out the phone number in the phone log directly by pressing the shortcut key ‘set’ in off state.
Page 19
TCL-IP (8) User Manual B、Setting the static IP Address Enter the “NETWORK” item in the same way, Press the “Set” key while the LCD displays “Local IP”, and the phone will enter the changing mode of the parameters. Press “set” key to make sure the IP address which displayed on the screen;and Press the“Set”key...
Page 20
Answer:Enter WEB page of the phone, click “Edition” menu, then can see version number, for example:2.0.0.1 3.How to restore the default setting of leaving factory for TCL-IP8? Answer:There are two ways to solve. (1)Enter the WEB page of the phone, then click the “factory default”...
Page 21
TCL-IP (8) User Manual 6.what kinds of voice codec can be selected for TCL-IP8? Answer:The default voice codec of TCL-IP8 is PCMU(G.711u).PCMU and PCMA both can supply better quality voice,but possess a big bandwidth which is up to 64kbps.If the network bandwidth is lower,you should select another lower Bit rate...
Need help?
Do you have a question about the IP phone and is the answer not in the manual?
Questions and answers