Page 1
INSTA L LATION AND OPERATING MANUAL This manual must be read and the requirements carried out to ensure satisfactory performance. DICKINSON RESERVES THE RIGHT TO MAKE CHANGES TO PRODUCTS OR DOCUMENTS AT ANY TIME Doug & Don Nov 5/2008 QUALITY INSPECTED BY-...
Important Read this owner’s manual carefully and completely before trying to assemble, operate, or service this fireplace. Improper use of this gas appliance can cause serious injury or death from burns, fire, explosion, carbon monoxide poisoning and oxygen depletion. Save this manual for future reference Contents Warnings and Disclosures pg-2...
- Use only approved materials, hose, regulators and fittings to install. 10ft Hose – ULC Type III CGA St 8.1 – Dickinson Prt# 19-100-10 20ft Hose – ULC Type III CGA St 8.1 – Dickinson Prt# 19-100-20 Propane Low Pressure Regulator UL/C.G.A –...
General This direct vent heater / fireplace is a clean burning gas appliance for use on board small vessels. The heater is furnished with a double walled vent pipe and cap. Fresh air is pulled from outside, through the outer pipe into the combustion chamber. Exhaust gas leaves the vessel through the inner pipe, while exchanging heat through the wall of the outer pipe to the cabin.
Page 5
This increases heating efficiency and provides good circulation of hot air. Mounting the heater lower will allow for more efficient circulation of heat in the cabin. The flue pipe of this heater is 28” long (71cm). Extensions are available in 10” (25.4cm) and 28”.
Page 6
Avoid low-points in vent pipe Clearance to surrounding surfaces Bending and installation of the vent pipe...
Page 7
Installing the Flexible Pipe Four springs are installed between the inside and outside pipe to ensure that an even air space is provided. It is important that two springs be located at any bend in order to prevent the pipes from touching. The length of pipe supplied is approximately 28" (71cm).
Page 8
WARNING: Do not install the external flue cap within 20 inches (500mm) of a refueling fitting or fuel tank vent.
It is necessary to install a pressure regulator for gas supplied from a propane bottle. For this type of installation we recommend using a Dickinson Low Pressure Kit (Part No. 19- 150) This Kit includes a pressure regulator (11 inch W/C) and a mounting kit. The kit must be mounted outside.
The diagram is to illustrate a typical installation only and should not be used to illustrate any particular regulatory code, insurance requirement or to override manufacturer’s instructions on any fittings or components. Install your propane system in accordance to local, national or industry specific regulations.
-10- Lighting Instructions 1) Open heater door 2) Turn GAS knob to LOW ( only) 3) Depress knob and light burner manually ( It may be necessary to keep clicking the lighter in order to keep the flame going to overcome the strong draft).
-11- Troubleshooting WARNING: WHAT TO DO IF YOU SMELL GAS • Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your vessel. • Leave the boat and ventilate with the appropriate equipment. •...
-12- Additional Accessories 19-000 inch (70cm) Direct Vent Pipe Extension 19-005 (approx.)including coupling inch (25.4cm) Direct Vent Pipe Extension (approx.)including coupling 19-151 Low pressure regulator only 19-150 Low pressure regulator and mounting kit (For use when there is no onboard propane system - for use with propane bottles) 19-100-10 10ft (3 m) CGA/AGA propane hose...
CLAIM PROCEDURE: In the event of a defect, problem or that a breach of this warranty is discovered, in order to protect any warranty rights you must promptly notify Dickinson. Give name and address, model name, location of unit, description of problem and where you can be reached during business hours.
-14- Return to: SINCE 1932 SINCE 1932 SINCE 1932 SINCE 1932 #407 – 204 Cayer Street, Coquitlam, B.C. Canada V3K 5B1 WARRANTY FORM I have read and understand the Limited Warranty and the Instruction Manual and agree to the terms and conditions (please print) Date……………………………………………………………………………...
Need help?
Do you have a question about the 00-NEW-P9000 and is the answer not in the manual?
Questions and answers