Listing And Displaying Startup-Config Files; Viewing The Startup-Config File Status With Multiple Configuration Enabled - HP ProCurve 2610-PWR Management And Configuration Manual

Switch Memory and Configuration
Multiple Configuration Files

Listing and Displaying Startup-Config Files

Command
show config files
show config < filename >
Viewing the Startup-Config File Status with Multiple
Configuration Enabled
.
Syntax:
For example, show config files displays the following:
6-26
Page
Below
6-27
show config files
This command displays the available startup-config files on
the switch and the current use of each file.
id: Identifies the memory slot for each startup-config file
available on the switch.
*
act: An asterisk (
corresponding startup-config file is currently in use.
*
pri: An asterisk (
corresponding startup-config file is currently assigned to the
primary boot path.
*
sec: An asterisk (
corresponding startup-config file is currently assigned to the
secondary boot path.
name: Shows the filename for each listed startup-config file in
the switch. Refer to "Renaming an Existing Startup-Config
File" on page 6-30 for the command you can use to change
existing startup-config filenames.
) in this column indicates that the
) in this column indicates that the
) in this column indicates that the