Adjustments - Cub Cadet LTX 1050 Operator's Manual

Deck Spindle
Grease fittings can be found on each deck spindle. See Fig. 6-4.
Lubricate with 251H EP grease or an equivalent No. 2 multi-
purpose lithium grease. Using a grease gun, apply two strokes
(minimum) or sufficient grease to the spindle shaft.

Adjustments

WARNING!
ignition key and engage the parking brake before
making adjustments. Protect your hands by using
heavy gloves when handling the blades.
NOTE: Check the tractor's tire pressure before performing
any deck leveling adjustments. Refer to Tires on page 25 for
information regarding tire pressure.
Leveling the Deck (Front To Rear)
The front of the cutting deck is supported by a stabilizer bar that
can be adjusted to level the deck from front to rear. The front of
the deck should be between 1⁄4" and 3⁄8" lower than the rear of the
deck. Adjust if necessary as follows:
1. Park the tractor parked on a firm, level surface and place
the deck lift lever in the middle position.
2. Rotate the blade nearest the discharge chute so that it is
parallel with the tractor.
3. Measure the distance from the front of the blade tip to the
ground and the rear of the blade tip to the ground. The
first measurement taken should be between 1⁄4" and 3⁄8" less
than the second measurement.
22 s 6 — M
ectiOn aintenance
Figure 6-4
Shut the engine off, remove the
& a
djustMents
Determine the approximate distance necessary for proper
adjustment and proceed, if necessary.
1. Loosen (thread outward) the hex lock nut on the end of the
deck hanger rod. See Fig. 6-5.
Figure 6-5
2. To raise the front of the deck, tighten (thread inward) the
inner hex nut against the front hanger bracket.
3. To lower the front of the deck, loosen (thread outward) the
hex nut, away from the front hanger bracket.
See Fig. 6-5.
4. Retighten the lock nut against the hex nut when proper
adjustment is achieved.