Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Cardinal Detecto MARINER WPS10
Summary of Contents for Cardinal Detecto MARINER WPS10
- Page 1 MARINER MODEL WPS10 WATERPROOF DIGITAL PORTION SCALE OWNER’S MANUAL CARDINAL SCALE MFG. CO. PO BOX 151 WEBB CITY, MO 64870 8528-M405-O1 Rev A PH (417) 673-4631 FAX (417) 673-5001 07/13 www.detectoscale.com Technical Support: Ph: 866-254-8261 techsupport@cardet.com...
-
Page 3: Table Of Contents
INTRODUCTION TABLE OF CONTENTS Thank you for purchasing our Detecto Model Installation …………………..………………. 1 WPS10 Waterproof Digital Portion Scale. Unpacking ……………………..………… 1 Power Supply …………………..………. 1 This manual will guide you through installation, Battery Pack…..………………..……….. 1 and operation of your scale. Please read it Battery Charging ........ -
Page 5: Installation
It will take approximately 5 hours to fully recharge the battery pack in the scale. While the batteries are charging the WPS10 can still be operated. Note that charging the battery pack for more than 12 hours will not damage it. -
Page 6: Display Annunciators
DISPLAY ANNUNCIATORS The annunciators are turned on to indicate that the scale display is in the mode corresponding to the annunciator label or that the status indicated by the label is active. The O annunciator is turned on when the weight display is stable. The lb annunciator is turned on to indicate that the displayed weight is in pounds. -
Page 7: Key Functions
KEY FUNCTIONS UNITS / 1. Press to change the weighing units to the alternate units of measurement (if selected during configuration of the scale). 2. Press and hold three (3) seconds to turn display back light on or off.- TARE 1. -
Page 8: Operation
OPERATION TURN THE SCALE ON Press the ON/OFF key to turn the scale on. The scale will display all display segments then change to zero weight. SELECT THE WEIGHING UNIT Press the UNITS key to alternate between the selected weighing units. NOTE: Multiple weighing units must be enabled during configuration for this function to be operational. -
Page 9: Configuration
CONFIGURATION The Scale has been pre-configured at the factory and should not require configuration for use in most applications. In the event that the factory settings do not meet the requirements of your application, the following describes the steps to configure the scale. TO BEGIN CONFIGURATION: 1. -
Page 10: Gravity Compensation
CONFIGURATION, CONT. GRAVITY COMPENSATION 1. With the display showing GrAu : To Enable the Gravity Compensation mode, press the SET key. The display will change to On (use the factory set value of 9.797). To Disable the Gravity Compensation mode, press the UNIT key. The display will change to OFF (use the value obtained from the factory Tech Support). -
Page 11: Display Messages
Over capacity CARE AND MAINTENANCE The heart of the WPS10 Waterproof Digital Portion Scale is a precision load cell located in the center of the scale base. It will provide accurate operation indefinitely if protected against overload of scale capacity, dropping items on scale, or other extreme shock.
Need help?
Do you have a question about the Detecto MARINER WPS10 and is the answer not in the manual?
Questions and answers