Directive 2009/125/EC for Energy-related Products (ErP). Follow all instructions. CAUTION: Do not use this apparatus near water. DENON EUROPE Clean only with dry cloth. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE Division of D&M Germany GmbH Do not block any ventilation openings.
Page 3
n CAUTIONS ON INSTALLATION NOTES ON USE WARNINGS • Avoid high temperatures. Allow for sufficient heat dispersion when installed in a rack. • Handle the power cord carefully. Hold the plug when unplugging the cord. • Keep the unit free from moisture, water, and dust. • Unplug the power cord when not using the unit for long periods of time.
Getting started Thank you for purchasing this DENON product. To ensure proper operation, please read this owner’s manual carefully before using the product. After reading them, be sure to keep them for future reference. Contents Operations ················································································9 Getting started ··············································································1 Operations ···················································································10...
To draw out the full potential of the HC single push-pull circuit, the operating parts inside the unit, causing the unit not to operate the power circuit uses DENON custom-specification block type properly. electrolytic capacitors, as well as SBD (Schottky-Barrier Diode) If this happens, let the unit sit for an hour or two with the power with short reverse recovery time and minimal current noise.
Preparations Preparations Here, we explain the connections and set up methods for this unit. F Cables used for connections vpage 4 F Connecting the speakers vpage 4 F Connecting pre out jacks vpage 7 F Connecting players vpage 7 F Connecting a recorder vpage 8 F Connecting the power cord vpage 8...
Connections Connections for all compatible audio signal format is described in Cables used for connections Connecting the speakers this operating instructions. Please select the types of connections corresponding to the equipment you are connecting. Select the cables according to the equipment being connected. Connecting the speakers cables NOTE Audio cable (sold separately)
If the protection circuit is activated even though there are no problems with the ventilation around the unit or in connections, the unit may be damaged. Turn off the power and then contact a DENON service center.
Page 9
Connecting the speakers Speaker connection (PMA-520AE only) Bi-wiring connection (PMA-720AE only) • When bi-wiring with bi-wireable speakers, connect the mid and high range terminals to SYSTEM (A) (or SYSTEM (B)), the low range terminals to SYSTEM (B) (or SYSTEM (A)). • This enables playback with minimal interference between the high-range speaker unit and the low-range speaker unit.
Connecting pre out jacks (PMA-720AE only) Connecting players If you use a power amplifier or subwoofer, connect it as shown below, and then you can use this unit as If humming or other noise is generated when the ground wire is connected, disconnect it.
Make sure the total power consumption of the connected devices does not exceed 100 W (0.43 A). n PMA-520AE z Illustrations is PMA-720AE. To household power NOTE outlet (AC 230 V, 50/60 Hz) NEVER insert the short-circuiting pin plug into the recording output. Doing so could result in damage.
Here, we explain functions and operations that let you make better use of this unit. F Before use vpage 10 F Starting playback vpage 10 F Adjusting the tone (LOUDNESS) vpage 11 F Setting speakers to use (PMA-720AE only) vpage 11 F Using headphone set vpage 11 F Starting recording vpage 11 F Setting the Auto Standby mode...
Operations Before use Starting playback Press the input source select Turn the VOLUME on the main unit all the way down. You can also use the following operation to select an input RECORDER button ( source. NETWORK PHONO n Using the knob on the main unit SOURCE DIRECT on the main unit to “...
Auto Standby mode “Off” Auto Standby mode “On” Press the input source select “Lit in red” “Unlit” button ( CD, NETWORK, PHONO, (PMA-720AE only) • The Power indicator flashes in red during Auto Standby mode TUNER ) to be recorded. setting. SPEAKERS A Press on the main unit.
Information Information Here, we list various information related to this unit. Please refer to this information as needed. F Part names and functions vpage 13 F Troubleshooting vpage 18 F Specifications vpage 19...
Part names and functions For buttons not explained here, see the page indicated in parentheses ( ). Front panel n PMA-720AE Power indicator ······································································· (10) Indicates the status of the unit’s as follows: • For several seconds after the power is turned on ·················································································Red (blinking)
Rear panel n PMA-720AE Input connectors (INPUTS) ······················································· (4) Input/output connectors (Recordings) (RECORDER) ············································································· (10) PRE OUT connectors ································································· (7) Speaker system terminals (SPEAKER SYSTEMS) ······························································· (4) AC OUTLET ················································································ (8) Power cord ················································································· (8) REMOTE CONTROL jacks Extension jack for future use.
Inserting the batteries Operating range of the remote control unit Point the remote control unit at the remote sensor when operating it. Bi-wiring connection (PMA-720AE only) q Remove the rear lid in the w Load the two batteries properly This method of connecting a speaker by using two speaker cables...
– When playing a • The needle pressure • Adjust to a proper needle – power, the power please contact the DENON record, the sound is incorrect. pressure. display flashes service adviser. distorted. • There is dirt on the tip of the • Check the tip of the needle.
Need help?
Do you have a question about the PMA-720AE and is the answer not in the manual?
Questions and answers