HP DMXTM 400/430 Operator's Manual page 27

If a label's edge is not detected within 12" (305 mm) of stock, the
Printer will stop feeding labels, (if this occurs, refer to Section 1.6
and reload the media). If a label edge is detected, the Printer will
begin to print the Self-Test pattern, see Figure 2-1 or 2-2
(depending on the Printer model) for an example of the Self-Test
Label). After the test pattern has successfully printed, the Printer
must be turned 'off' and then turned 'on' again to reset the Printer.
TUE JANUARY 25, 1997 Ø9:29 Ø25
VER: DAØ1 - Ø1.Ø1 12/25/93
ROM CHECKSUM U15 FFFF
ROM CHECKSUM U19 FFFF
MCU CHECKSUM U32 GOOD
SERIAL PORT BAUD IS 96ØØ
TRANSFER SWITCH IS OFF
SETUP SW-A
SETUP SW-B
ANALOG INPUT VALUES:
PAPER :229
POT :133
INCH COUNTER
TOTAL LABEL LENGTH IN INCHES:
DMX 400/430 Operator's Manual
Setting Up Your Printer
47-2014-01A
47-2015-01A
46-22ØØ-Ø1C
1 2
OFF OFF OFF OFF OFF OFF OFF OFF
1 2
OFF OFF OFF OFF
EDGE: 173 REFL : 195
TOFA: 153 RIBN : Ø27
DATE SET:
Figure 2-1 DMX 400 Test Label
MCU INT RAM CHECKS GOOD
MCU EXT RAM CHECKS GOOD
SYSTEM RAM CHECKS GOOD
MODULE CHECKSUM: 7E8B
3 4 5 6
3 4
TEMP : Ø62
RWND : 013
ØØ/ØØ/ØØ
44
7 8
24VOLT : 198
17