Advertisement
Quick Links
Advertisement
Related Manuals for Yamaha Pickup Mute
Summary of Contents for Yamaha Pickup Mute
- Page 1 Pickup Mute ™...
- Page 2 Pickup Mute ™ Thank you for purchasing the Yamaha SILENT BRASS Pickup Mute . In order to obtain the ™ ™ maximum performance and enjoyment from your Pickup Mute ™ , we urge you to read this Owner’s Manual thoroughly before using. Please keep this Owner’s Manual in a safe place for later...
-
Page 3: Specifications
■ Pickup Mute ™ Specifications Pickup Mute ™ Instrument Dimensions (diameter x length) Width at handle Weight 70 x 145 mm Piccolo Trumpet — (2-3/4" x 5-11/16") (2.8oz.) Trumpet, 70 x 200 mm 120g — Cornet (2-3/4" x 7-7/8") (4.2oz.) Flugelhorn, — Alto Trombone 270g (9.5oz.) Trombone, 108 x 270 mm — Bass Trombone (4-1/4" x 10-5/8") 300g... -
Page 4: Special Message Section
SPECIFICATIONS SUBJECT TO CHANGE: The information contained in this manual is believed to be cor- Location ■ rect at the time of printing. However, Yamaha reserves the right Do not expose it to the following conditions to avoid to change or modify any of the specifications without notice or deformation, discoloration, or more serious damage. -
Page 5: Setup And Use
Set up and Use ™ ■ Personal Studio Connecting Cable Stereo Earphones PM7 for TRUMPET PM6 for FLUGELHORN PM5 for TROMBONE Lock Nut PM9 for PICCOLO TRUMPET Handle (P. 17) PM3 for FRENCH HORN PM2 for EUPHONIUM Handle... - Page 6 Stereo Earphones Head ■ Assembling the PM1 Connecting Cable Handle Lock Nut Body Lay the Head on the floor. Inner Head Hook Place the Body on the Head and Fully extend the Inner fasten with the three hooks. Head that is located in the center of the Head. PM1 for TUBA * Refer to pg.16 for instructions on attaching the Pickup Mute ™ to the instrument.
- Page 7 QUICK GUIDE ■ Attach the Pickup Mute ™ PM1 to the Tuba Attaching and removing the PM9/PM7/ Pickup Mute ™ PM6/PM5/PM3 As shown in the illustration, hold the instrument with your left hand and, while turning the Pickup Mute ™ , firmly insert it into the bell with your right hand. After assembling the PM1 (refer to Holding the PM1 with both hands, Adjust the PM1 so that it is posi- pg. 15) lay it on its side. gently insert the Inner Head into tioned in the center of the bell. While seated, hold the tuba the bell of the tuba. (Continue...
- Page 8 Mute ™ from the instrument. Clean any moisture fingers. The handle also features a ring for a ™ with a cloth. DO NOT WASH on the Pickup Mute wrist band, allowing you to hang the Pickup WITH WATER. ™ Mute from your wrist (just like any other mute) while emptying the horn. (Wrist band ● If moisture gets on the Pickup Mute ™ during or is not included.) after playing, please dry thoroughly. * Always remove the Pickup Mute ™ before emptying the instrument.
- Page 9 QUICK GUIDE Pickup Mute Stereo Earphones Insert firmly Signal path Tighten the From OUTPUT/ Lock Nut PHONES Connect the supplied cable to the Pickup Mute ™ output jack and tighten the LOCK NUT. To INPUT Disconnecting the cable while the Don’t step power is ON may result in damage to on the cable the unit. The sudden noise may also may result in hearing impairments.