HP 650C User Manual page 39

Action buttons:
Cancel stops current
operation (plotting,
accuracy calibration,
pen alignment and
media loading).
Form Feed/Cut advances the page and,
if roll media, cuts it.
Access Pens brings the pen carriage out to the
plotting area for pen access. (Plotter window
must be closed).
To select and confirm a menu option, do the following:
1. Press the Enter button to move from the ªStatusº display to the menu structure.
2. Press either the up ( =
menu level.
3. When the menu or option you want is displayed, press the
4. Repeat from step 2 to reach the next level or sublevel of options you want to set.
Many menus contain subgroups of plotter options. Pressing
plays the next level of options. When you have reached the final level of
your option, pressing Enter confirms your menu selection or value. In many
instances, your choice is saved in the plotter's continuous memory. This
means it is not erased or reset when you turn OFF the plotter.
To exit to a previous menu, press the
button will move you to higher levels of the menu structure until you reach the ªStatus' dis-
play. If you are in a menu that has variables, pressing
menu without changing any values or without saving any menu changes. You can confirm
menu changes only by pressing
Cancel Form Feed/Cut
) or down ( O
) arrow button to review the options at the current
Note
Previous button. Continuous pressing of the
Enter.
Installation and Configuration
Access Pens
Pause stops plotter after
plotting current drawing.
Press again to continue.
Enter button.
then dis-
Enter
Previous returns you to the previous
Pause
Previous
3-19