Connecting The Ps-126 Power Supply; Power Supply Connections; Connecting A Non-Icom Dc Power Supply - Icom IC-7100 Basic Manual

Power Supply Connections

Make sure the [PWR]
necting the DC power cable.
• We recommend using Icom's optional power supply
(PS-126: DC13.8 V/25 A).
D Connecting the PS-126 power supply
Use the attached AC cable to con-
nect to AC outlet.
Rear panel
GND
L eft D isplay R ight
C enter
(L) switch is OFF before con-
PS-126
To
[DC 13.8V]
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
INSTALLATION AND CONNECTIONS
The transceiver needs followings:
• DC 13.8 V (Capacity: 22 A and over)
• A power supply with an over current protective line
and with a less voltage fluctuation or ripple
D Connecting a non-Icom DC power supply
Connect the black DC power cable to the (–) Negative
terminal, and the red DC power cable to the (+) Positive
terminal.
Rear panel
GND
DC power socket
For European versions
GND
DC power socket
RWARNING! (About DC power supply)
• Make sure DC power cable polarity is correct.
Red: Positive + terminal
Black: Negative – terminal
• NEVER cut the DC power cable between the DC
plug and fuse holder.
• DO NOT use unattached or undesignated DC pow-
er cable.
• DO NOT forcibly pull or bend the DC power cable.
Install the devices far enough from the place where
people might put things or step on the DC power
cable.
2-7
AC outlet
Stabilized power supply
Fuse
holder
RED
BLACK
OPC-1457
Connect to
power supply
OPC-2095
2