Winegard TRAV'LER SK-1000 Installation Manual
Automatic multi-satellite dish/bell tv antenna
Hide thumbs
Also See for TRAV'LER SK-1000:
- Owner's manual (10 pages) ,
- Operation manual (8 pages) ,
- Installation manual (2 pages)
Advertisement
Automatic
Multi-Satellite
TV Antenna
Model SK-1000
TRAV'LER
DISH
/Bell TV
Antenna
™
®
®
www.winegard.com/mobile
For Technical Services, email help@winegard.com or call 1-800-788-4417
For Receivers and Programming, call 1-866-609-9374
For up-to-date information on receiver compatibility and programming,
visit www.winegard.com/receivers
Product Registration
Please register your Winegard product by filling out and returning the Product Registration Card
provided or by completing the online registration form at http://www.winegard.com/registration.
2452238
Advertisement
Table of Contents
Related Manuals for Winegard TRAV'LER SK-1000
Summary of Contents for Winegard TRAV'LER SK-1000
- Page 1 For Receivers and Programming, call 1-866-609-9374 For up-to-date information on receiver compatibility and programming, visit www.winegard.com/receivers Product Registration Please register your Winegard product by filling out and returning the Product Registration Card provided or by completing the online registration form at http://www.winegard.com/registration. 2452238...
-
Page 2: Specifications
Specifications Depending on location and DISH receiver type, the following satellites can be accessed with the SK-1000 during automatic operation: 110°, 119°, 129°. Depending on location and Bell TV receiver type, the following satellites can be accessed with the SK-1000 during automatic operation: 82°, 91°. -
Page 3: Clearance Requirements
Also, check that there are no obstructions (such as tree limbs) above the antenna that will prevent it from raising. At its highest point, the antenna will extend to 37” above the roof to which it is mounted (see fig. 3). FIGURE 3. Range of motion for TRAV’LER SK-1000 antenna Parts Mount Base with 30’... -
Page 4: Choosing A Location For Cables To Enter The Vehicle
Make sure cables are long enough to reach their destination points inside the vehicle. For cable CL-SK26 runs longer than 30’, an extension may be purchased. Winegard recommends using Model CL-SK26 25’ extension cable. Do not exceed 55’ of cable! -
Page 5: Installing The Antenna
FIGURE 6. Antenna (without reflector) installed parallel to centerline of RV SKA-004 When installing the antenna on a rubber roof, Winegard recommends using Model SKA-004 roller plate, which is designed to create a solid landing area for the roller. If not using this plate, make sure that the roller does not come in contact with any rib supports or bubbles in the roof when in operation. -
Page 6: Installing The Reflector
Overall Setup 1. Drill a 1″ hole in the roof, and push the power/control cable and coax cables through the hole. Place the supplied cable entry plate over the hole and cables, and screw the plate in place using eight of the supplied mounting screws. Seal the plate and screw holes with approved sealant (not included). - Page 7 Winegard Company, 3000 Kirkwood Street, Burlington, Iowa 52601, Telephone 800-288-8094 or visit www.winegard.com). Customer must provide proof of purchase with a dated sales receipt for the Winegard product to verify the product is under warranty. If the date of purchase cannot be verified, the warranty period shall be considered to begin thirty (30) days after the date of manufacture.
- Page 8 For Receivers and Programming, call 1-866-609-9374 For up-to-date information on receiver compatibility and programming, visit www.winegard.com/receivers Product Registration Please register your Winegard product by filling out and returning the Product Registration Card provided or by completing the online registration form at http://www.winegard.com/registration. 2452238...
- Page 9 3. The interface screen will display seconds or until the TRAV’LER release “POWER.” the type of satellite dish on the interface displays “POWER ON.” top line. WINEGARD COMPANY connecting to SM Dish 1000 antenna POWER ON Ready: Multi-Sat 4. The TRAV’LER antenna will enter 5.
- Page 10 Then, press and hold “ENTER for and then press the Enter button to “SELECT” until the asterisk is next to two seconds. confirm the selection. “Installation,” and press “ENTER.” WINEGARD COMPANY Enter User Menu? Installation* *Yes No POWER ON Exit 4.
-
Page 11: Manual Operation
211 receiver. If your receiver differs from the options shown below, you may need to consult your ® receiver manual. The wording and display used in yoru receiver may differ slightly. Check out online receiver setup guides for your antenna at www.winegard.com/receivers/setupguide.php. Press “Menu” on your remote. Select Select option 1, “Installation.” Then, Select “Check... -
Page 12: Troubleshooting
Winegard Technical Support at help@winegard.com or 1-800-788-4417. AZ MOTOR STALLED Something is preventing the mount from rotating; look for obstructions. If there is no obvious obstruction, contact Winegard Technical Support at help@ winegard.com or 1-800-788-4417. EL MOTOR STALLED Something is preventing the mount from raising or lowering; look for obstructions.
Need help?
Do you have a question about the TRAV'LER SK-1000 and is the answer not in the manual?
Questions and answers