NAD VISO 1 Owner's Manual page 6

IDENTIFICATION OF CONTROLS
1 POWER BUTTON
• Press this button to switch ON the VISO 1. When the POWER button
is pressed, the blue POWER indicator flashes continuously and then
eventually gets fixed to blue.
• Press again the POWER button to switch OFF the VISO 1.
2 USB
• VISO 1 may need a software update to be in step with the latest
technology trends. Check with your authorized NAD distributors for
future software updates. Only authorized NAD distributors or service
centers are allowed to implement a software update.
• Connect to this input a USB memory stick containing the software
update. Use USB adaptor when necessary.
3 S/PDIF (OPTICAL)
• Connect OPTICAL IN to corresponding optical output of sources
such as CD, DVD or BD players, digital cable box, digital tuners and
other applicable components.
4 COMPONENT VIDEO OUT
• Connect Component Video Out to the Component Video input of a
compatible video monitor/TV.
• Be sure to observe consistency in connecting the Y/Pb/Pr jacks to
the corresponding devices.
• Refer also to the item about COMPONENT VIDEO OUTPUT at the
VISO 1 FEATURES section.
5 AC MAINS INPUT
• The VISO 1 comes supplied with a separate detachable mains power
cord. There are 2 supplied power cords – select applicable type for
your usage. Before connecting the plug to the mains powers source,
connect firmly first the other end to VISO 1' s AC Mains input socket.
• Always disconnect the mains power plug from the mains power
source first, before disconnecting the cable from the VISO 1's AC
Mains input socket.
• Power Rating : 100 - 240V ~50/60Hz 35W
VISO 1 REMOTE CONTROL
S
+
9 4j
-

VISO 1
6
S Select through Sources.
+/- Increase or decrease loudness level.
0 Skip forward to the next song.
0
9 Skip back to the previous song.
uj Start playback. Pause playback temporarily.
Press and hold to toggle iPod video output between connected TV and iPod's own display screen
(applicable only to iPod models that support component video signal)
X
Temporarily mutes audio output or restores audio from mute mode.
6 S, +/-
• Toggle "S" button to step through the Sources in the following order
– Docked iPod, Bluetooth device and S/PDIF input source device.
• Press "+" to increase the volume level; " - " to lower it.
7 CONNECTOR COVER
• Use to protect the pin connectors.
• Remove before docking an iPod
IMPORTANT NOTE ABOUT THE PIN CONNECTORS
Playback of a docked iPod maybe impaired if the pin connectors are dirty.
Ensure that the VISO 1 pin connectors are clean, free of any lint or any other
contaminations. Ensure the same with the corresponding pin connectors
of the iPod model you will be docking into the VISO 1.
8 DOCKING CRADLE
• Remove the dock's connector cover before docking an iPod player.
• The docking cradle can be rotated 90 degrees allowing for "portrait"
or "landscape" orientation of applicable iPod models.
• Your iPod will be charged while it is docked to the VISO 1.
9 POWER INDICATOR
• When the POWER button is pressed, the blue POWER indicator
flashes continuously and then eventually gets fixed to blue.
• The blue POWER indicator will flash when the source is changed or
a remote control command is received.