Preparing To Install The - GE 2 Owner's Manual

Preparing to install the refrigerator.
Read these instructions completely and carefully.
Door reversal
Model 3
1. Remove the small plug button on the left side of the door
top cap.
2. Remove the three plug buttons or screws on the left side on
top of the cabinet.
3. Remove the plastic hinge cover by lifting it up by the
front edge.
4. Remove the three screws from the top hinge.
5. Lift the door up and off the bottom hinge (right side).
6. Tilt the refrigerator cabinet back to remove the right
leveling leg.
7. Remove the screws on the bottom hinge (right side) and the
left leveling leg. Move the bottom hinge to the left side and
secure it with the screws and leveling leg.
IMPORTANT: The left leg has a spacer that must be moved to the
right side leveling leg when the door swing is reversed.
8. Screw the right leveling leg, with the spacer in place, back in
place on the right side.
9. Position the door on the left bottom hinge. With the
magnetic gasket holding the door in place, secure the top
hinge with screws.
10. Make sure the door is aligned with the refrigerator cabinet
before continuing.
11. Replace the hinge cover on top of the hinge.
12. Put the plug button in the hole on the right side of the
door cap.
13. Put the three plug buttons or screws on the right side on
top of the cabinet.
8
Hinge cover
Plug buttons
or screws
Plug button
Spacer
Leveling legs
Hinge
Bottom hinge