Kenwood CMOS-320 Instruction Manual page 5

8
Display the camera video.
Before viewing the camera, apply the parking brake
and chock the wheels so that the vehicle will not move.
Otherwise, an unexpected accident may result.
For displaying the camera video, read the instruction manual
for your video monitor.
When the camera is installed as a rearview
camera:
Change the shift lever to the R (Reverse) range
to view the image of the rear of the vehicle.
When the camera is installed as a front camera
(CMOS-320 only):
Refer to the instruction manual of the unit that
you have connected this camera to, and display
the image of the front of the vehicle.
9
Adjust the camera angle.
When adjusting the camera angle, be careful not to stretch
the camera cord.
When installing CMOS-220 as a rearview
camera:
Adjust the angle so that the rear of the vehicle or the bumper
can be seen at the bottom of the monitor.
When installing CMOS-320 as a rearview
camera:
Refer to "Display View Switching" (page 14) and switch the
image to [Overhead View]. Adjust the camera angle so that
the guideline and the parking lines become vertical.
Vehicle rear part or bumper
Guideline
When installing CMOS-320 as a front camera:
Before adjusting the camera angle, perform "Camera ID
Setting" (page 13) and "Camera Setting Procedure" (page
10).
When you select [Standard] for "Mounting Position Setting",
switch the image to [Overhead View] (page 14) and adjust
the camera angle so that the guideline and the parking lines
become vertical.
When you select [Lower] for "Mounting Position Setting",
switch the image to [Corner View] (page 14) and then adjust
the angle of the camera to straighten the ground lines in the
left and right screens.
10
Set the camera.
When using CMOS-320 as a rearview camera:
Refer to page 9 to 13 and perform "Preparation Before
Camera Setting", "Overhead View Image Adjustment" and
"Wide View Guideline Adjustment".
When using CMOS-320 as a front camera:
When you select [Standard] for "Mounting Position Setting",
refer to page 9 to 13 and perform "Preparation Before Camera
Setting", "Overhead View Image Adjustment" and "Wide
View Guideline Adjustment".
When you select [Lower] for "Mounting Position Setting",
refer to page 9 to 13 and perform "Preparation Before Camera
Setting" and "Overhead View Image Adjustment". You cannot
perform "Wide View Guideline Adjustment".
11
After adjusting the camera angle, tighten the
retaining screws firmly.
Inspect the retaining screws at times. If they are loose,
tighten them firmly.
Next page 3
5
|
CMOS-320/CMOS-220