Step 2 Error Messages; Step 4 Error Messages - Sharp LL-S201A Operation Manual

Error message

Step 2 Error messages

Error
Multiple LL-S201A More than one LL-S201A is connected. Connect only one
LL-S201A for updating.
Screen resolution The screen resolution should be set to 1920x1080.
USB connection USB cable is not connected.
Video connection Can't update! There is a problem with input setting or
video signal.

Step 4 Error messages

If an error occurs while an update is in progress, the message "Error occurred" appears on the screen,
and a message is displayed with a solution.
Error
USB USB communication error has occurred. Please turn the power of LL-S201A and try again from the
communication beginning.
Data error Failed to recognize the firmware data. Please try again from the beginning.
Version error There was an error in the version check. Please try again from the beginning.
Battery Low Battery voltage is too low. Connect the AC adaptor, allow battery to charge and try again from the
beginning.
Fatal error A fatal error has occurred.
When the power of LL-s201A is turn on and the panel does not start, please contact Sharp's service center.
If LL-S201A starts, please try the update from the beginning.
Other error An unexpected error has occurred. Please exit the program and try again.
Message
Message
Solution
Confirm only one LL-S201A is connected during
update.
Change screen resolution to 1920x1080.
Make sure desktop item size is set to 100%.
Check the USB cable connection.
Check the format of the output signal and
connection of LL-S201A. Please try again from
the beginning.
12