Installing The Control Panel - Miele G 890 Operating Instructions Manual

Dishwasher installation

3. Installing the Control panel

The control panel and hardware is packaged separately from the dishwasher. It
should be installed using the follwing procedure.
If a GDU decor kit is being used, (to
convert an "i" dishwasher to a "U" ver-
sion), the spacer bars
removed and stored for possible use
in the future, (See the separate in-
structions for installing the GDU
decor kit). If the GDU kit is not being
used, skip the following step.
To remove the spacer bars from the
control panel, place the panel on a
table, printed side up, and gently
push down on the spacer bars at a
point near the bottom of the control
panel. This will release the mounting
bolts from their slots.
54
i
must first be
Install the necessary spacer bars on
the control panel.
Place the large cap
ON/OFF button.
Place the two small caps with one
c
straight edge on to the "+" and
"–" buttons. The straight edges must
face each other.
Place the 12 small oval caps
other button.
e
Place the seal
the rear of the ventilation grille
then push the ventilation grille into
the metal backing plate.
Position the control panel
backing plate and fasten it from the
inside of the door
screws provided.
b
on the
d
onto
in the groove on
f
,
g
over the
h
using the six