Download Print this page

Troubleshooting; Limited Warranty - Tamarack Technologies HV1000 Product Manual & Installation Manual

Hv series whole house cooling fans

Advertisement

Troubleshooting

HV1000:
The most common problem with the HV1000 is caused by incorrect wiring. Before you check anything else make sure:
WHITE wire in HV1000 is connected to 115 VAC Line Neutral; RED wire in HV1000 is connected to 115 VAC Line Hot (Constant Hot
Feed); BLACK wire in HV1000 is connected to a switch that will make it hot when the switch is closed.
HV1600:
If the wireless remote fails to activate the fan, the batteries may need replacing. The transmitter uses two type CR2016 3V
coin cell batteries. Remove the back plate from the transmitter and remove the batteries. Following the markings above the battery
holders, replace the batteries. Secure the back plate to the transmitter.
Switch
Doors
On
Do Not Open
On
Do Not Open
(audible "click")
Off
Do Not Close
On
Both Open
On
Both Open- One
closes then
opens ...
Off
Both Closed-
One opens then
closes...
Our unique energy saving system, the R-Gardian, is designed for homes with blown in insulation and will protect
your insulation when using an HV Whole House Cooler. The R-Gardian may be purchased separately.

LIMITED WARRANTY

If, within the period of three years from the date of purchase, the HV 1000 or HV 1600 (the Product) is defective or
malfunctions in normal home use, Tamarack Technologies, Inc. will repair or replace the Product at its discretion without
charge for labor or materials. Customer is responsible for shipping charges. NOTE: Some states codes require fans to be
hardwired. Hardwiring of the HV1600 will not void warranty provided the wiring is performed by a licensed electrician.
Conditions, Exclusions, and Limitations-This Warranty is subject to the following conditions, exclusions and limitations:
T
W
HIS
ARRANTY DOES NOT COVER PROBLEMS RESULTING FROM INSTALLATION
UNDERTAKEN OTHER THAN IN ACCORDANCE WITH THE INSTRUCTIONS
FROM DEFECTS IN OR CAUSED BY ASSOCIATED EQUIPMENT
ATTEMPTED BY PERSONS OTHER THAN
G
. T
W
OF
OD
HIS
ARRANTY DOES NOT APPLY TO THE
C
. E
AND
ANADA
XCEPT AS SET FORTH ABOVE
T
, I
.
ECHNOLOGIES
NC
AND ALL OTHER SUCH WARRANTIES ARE EXPRESSLY DISCLAIMED
FITNESS FOR ANY PARTICULAR PURPOSE SHALL BE LIMITED TO THE WARRANTY HEREUNDER
T
T
AMARACK
ECHNOLOGIES
T
T
SHALL
AMARACK
ECHNOLOGIES
,
COMMERCIAL DAMAGES
IRRESPECTIVE OF THE CAUSE THEREOF
INCLUDING WITHOUT LIMITATION ANY DAMAGES TO ANY PART OF A BUILDING OR ITS CONTENTS
N
: S
OTE
OME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES AND SOME
STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS
. T
W
NOT APPLY TO YOU
HIS
.
STATE TO STATE
©Tamarack Technologies, Inc.• 320 Main Street • Buzzards Bay, MA 02532
508-759-4660 • 800-222-5932 • Fax 508-759-6001
Fans
Do Not Run
Do Not Run
Stop
One Fan Runs
One Fan Runs
Stop
T
T
AMARACK
ECHNOLOGIES
P
,
NO EXPRESS OR IMPLIED
, I
.
NC
FOR THE PRODUCT SHALL BE LIMITED TO THE REPLACEMENT VALUE OF THE PRODUCT
, I
.
NC
BE LIABLE FOR ANY INCIDENTAL DAMAGES OR FOR ANY CONSEQUENTIAL PROPERTY OR
ARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS THAT VARY FROM
Possible Cause
No Power
No constant power on RED
RED and BLACK are connected
together
Something blocking fan rotation
Door motor gears or switch may
have been stressed during
installation. Framing opening may
be too small.
Door motor gears or switch may
have been stressed during
installation. Framing opening may
be too small.
,
. T
W
HIS
ARRANTY DOES NOT COVER PROBLEMS RESULTING
(
,
FURNACES
SOLARIA
, I
.;
NC
FROM ABUSE
RODUCT USED OUTSIDE THE
W
ARRANTY IS GIVEN OR AUTHORIZED BY
,
OCCURRING EITHER DURING OR AFTER THE WARRANTY PERIOD
Try
Check connections and circuit breakers
Check wiring connections. There must be
constant power on the red wire.
Check wiring connections. Connections at the
fan must be made individually.
Turn the power off and check for foreign
matter blocking blade rotation.
Remove fan from between joists and test
operation while fan is sitting on top of joists. If
the fan operates, enlarge the opening and
return the fan to installed position.
Remove fan from between joists and test
operation while fan is sitting on top of joists. If
the fan operates, enlarge the opening and
return the fan to installed position.
OPERATION OR MAINTENANCE THAT HAS BEEN
,
.);
ETC
FROM REPAIRS OR MODIFICATIONS
,
ACCIDENTAL OR SHIPPING DAMAGE OR ACTS
U
S
,
NITED
TATES
ITS TERRITORIAL POSSESSIONS
. A
NY WARRANTY OR MERCHANTABILITY OF
. M
,
OREOVER
ANY LIABILITY OF
.
,
SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY
,
T
AMARACK
. I
N NO EVENT
,
www.tamtech.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the HV1000 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Hv1000-dbHv1600Hv1600-gdr