Cub Cadet Tank S S7237 Operator's Manual page 13

To adjust the tilt of the steering wheel:
1. Pull back on the adjustment lock lever to loosen the
steering wheel tilt. See Fig. 3-10.
Loosen
Tighten
Figure 3-10
2. Place the steering wheel in the desired angle and lock into
place by pushing the adjustment lock lever forward until
the steering wheel is secure.
Proper steering column and seat adjustment will result in the
following (to adjust the seat see Suspension Seat below):
In the neutral position with hands on the steering wheel,
• Operator's upper arms should be relaxed and
approximately vertical.
• Operator's forearms should be approximately horizontal.
• Operator's back should stay in contact with the seat back.
• Steering column should not contact operator's legs.
Check the results of any adjustments to the conditions described
above. Repeat any adjustment procedures as required until all
conditions are met.
Suspension Seat
This tractor is equipped with an adjustable suspension seat
system, which includes a seat with retractable seat belt assembly,
a low profile mechanical suspension, and an Operator Presence
Sensor (OPS). The OPS in the form of a switch, is integrated into
the seat bottom and is connected to the machine electrical
system.
The seat has several adjustments to meet the individual needs of
the operator. Refer to Fig. 3-11 for the following adjustments.
Seat Adjustment
Lever
Mechanical Suspension
Mechanism
Figure 3-11
Seat Position
1. To adjust the position of the seat, pull forward and hold the
seat adjustment lever. Slide the seat forward or rearward
to the desired position; then release the adjustment lever.
Make sure seat is locked into position before operating the
tractor.
Arm Rests
1. To adjust to the arm rest rotate the roller bearing, single-
locking knob on the bottom of the arm. The angle of the
arm can move up or down.
Mechanical Suspension Mechanism
1. To adjust the mechanical suspension mechanism, there
is a lever on the front of the seat with an orange colored
indicator arrow and guage.
2. Sit down in the operator's position and look down at the
center of the seat, flip the lever out towards the right and
pull upward on the fold-out lever and "pump up" to increase
seat load capacity and firmness. Push the lever downward
to reduce the firmness and load capacity. Just center the
orange-colored indicator on the guage to achieve your
exact weight setting.
Lumbar Support
1. The knob on the back left of the operator's seat can change
the lumbar support from the top portion of the seat, to the
lower portion and off. Rotate the knob to set the support to
the desired area.
s
ectiOn
Lumbar
Support
Knob
Arm Rest
Adjustments
2 — a & s -u
sseMbly et p
13