Steering Wheel; Install Operator’s Seat - Cub Cadet RZT-S Operator's Manual

Steering Wheel

1. Remove the hardware for attaching the steering wheel
from beneath the steering wheel cap. Carefully pry off the
steering wheel cover to remove the hardware.
2. With the wheels of the tractor pointing straight forward,
place the steering wheel over the steering shaft.
3. Place the flat washer and belleville washer over the steering
wheel and secure with the hex screw. See Figure 3-3.
Hex Screw
Belleville Washer
Steering Wheel
Column
4. Place the steering wheel cover over the center of the steering
wheel and push downward until it "clicks" into place.
10 S 3— A
ection SSembly
Steering Wheel Cover
Steering Wheel
Figure 3-3
& S -U
et p
Install Operator's Seat
To install the seat proceed as follows:
NOTE: The seat is shipped with the seat switch and seat pan
attached. A second person may be needed to hold the seat.
1. Cut any straps securing the seat assembly to the tractor.
Remove any packing material.
NOTE: Be careful not to cut the wiring harness connecting the
seat and the seat switch in the bottom of the seat.
2. Remove the two shoulder screws in the seat pan as shown
in Figure 3-4.
Figure 3-4
3. Rotate the seat into position and secure the seat into place
with the previously removed shoulder screws. Be careful
not to crimp or damage the wire harness while installing
the seat. See Figure 3-5.
Figure 3-5
NOTE: Be sure to push the excess wire from the wire harness into
the seat box hole before continuing.