Diagnostic Fault Codes - Rascal LiteWay 214 Owner's Manual

Rascal LiteWay 214 & 224 Owner's Manual

DIAGNOSTIC FAULT CODES

Your scooter controller provides diagnostic information in the form of a flash
code. The LED Status light on the battery gauge flashes to indicate a
problem has been detected. When switching on, the controller conducts a
diagnostic test. While this test is in progress the light will flash, if no fault is
detected the light will remain solid. If a fault is detected, the light will flash a
sequence of flashes to indicate what the fault is.
So for Instance if the lamp flashes twice in short succession and then again
twice in short succession, this indicates a bad motor connection. If the lamp
flashes 8 times there is a problem detected in the controller.
Number
Indicated fault and corrective action
of

Flashes
1

2

3

4 & 5

6

7

8

9

10
Battery needs recharging or bad connection with batteries.
Check connections and recharge batteries.
Bad motor connection. Request assistance from dealer who
will check all connections between controller and motor,
Short circuit between motor and battery connection.
.
Contact dealer
Not used
Controller inhibited from operation. Disconnect battery
charger and check if problem is resolved. Otherwise
contact your dealer.
Throttle fault. Finger control levers must be in neutral
(centered) position before key is turned on. Switch scooter
off, center levers, and switch back on. If problem persists,
contact dealer for service
Controller Fault. Inform dealer. Dealer will check
connections and test controller.
Scooter left in freewheel or has bad parking brake
connection. Lock into drive position and switch scooter off
and on. If this fails to cure the problem, inform dealer and
they will check the parking brake and connections.
Excessive voltage detected at controller. Check battery
connections
EMC Part: 43132600 ~ Rev.02 ~ 08/24/10
18
.