Table of Contents
Advertisement
Connector
Connect to
4 Red wire
The +12V power terminal
which is live in the accessory
(ACC) position of the ignition
switch. If there is no accessory
position, connect to the +12V
car battery terminal that is
always live. Make sure that the
black ground (earth) lead is
connected to a metal surface of
the car first.
5 Green and
Left speaker (rear)
green/black
wires
6 White and
Left speaker (front)
white/black
wires
7 Gray and
Right speaker (front)
gray/black
wires
8 Purple and
Right speaker (rear)
purple/black
wires
2
Connect the other end of the supplied
standard connector to the car audio
system.
a
b
f
g
h
c
e
d
Connector
1
ANTENNA
External Mic
2
SUBWOOFER
3
(Socket)
REAR LINE OUT L
4
(Socket)
5
REAR LINE OUT R
(Socket)
6
OE REMOTE
(Brown)
FRONT LINE OUT L Front left speaker
7
8
FRONT LINE OUT
R
Tip
•
The pin arrangement for the ISO connectors depends
on the type of vehicle you drive. Be sure to make
proper connections to prevent damage to the system.
Mount into the dashboard
Note
•
If your car has no an on-board drive or navigation
computer, disconnect the negative terminal of the car
battery.
•
If your car has an on-board drive or navigation
computer, the computer may lose its memory when
you disconnect the car battery.
•
If the car battery is not disconnected, to avoid short-
circuit, make sure that bare wires do not touch each
other.
Connect to
Antenna for radio
An external
microphone for
phone call
Subwoofer
Rear left speaker
Rear right speaker
OE remote
Front right speaker
EN
7
Advertisement
Table of Contents
