Casablanca 99019 Quick Start Manual

Installation
OFF
Before installing the Universal Remote Remove the canopy. If uncertain
Control Receiver, use the pull chains to how to remove it, reference the fan's
set the fan speed to HIGH and the light owner's manual. With wiring exposed,
to ON. Be sure power is OFF before it may be helpful to note existing wire
proceeding with installation.
connections or take a digital photo for
reference. Remove the wire connectors
that were connecting the wires from
the outlet box to the fan, leaving the
grounding wires connected.
Wiring
blue (light out)
black (fan out)
white (common out)
CONNECT WIRES FROM RECEIVER TO FAN -Using the blue wire connectors connect the white wire from the
receiver (marked "common out") to the white wire from fan. Connect the black wire from the receiver (marked
"fan out") to the black wire from the fan. Connect the blue wire from the receiver (marked "light out") to the
blue wire (or possibly black with white stripe) from the fan.
Note: The red wire from the receiver has a pre-installed wire terminator. It is for fans with an optional up light;
otherwise it will not be used. Maximum 120 watts.
If you're uncertain about wire colors or connections, please contact a qualified electrician.
Turn the splices upward and push them carefully back through the hanger bracket
into the outlet box. Spread the wires apart, with the grounded wires on one side of the
outlet box and the ungrounded wires on the other side of the outlet box.
Universal

Remote Control

Transmitter &
Receiver
Model 99019
Receiver
OR
Canopy
Choose the hanging system that most closely resembles the one used by your fan and install the receiver and wire as directed.
Note: Some fans may have considerable excess lead wire. For easier canopy installation, cut the excess wire, leaving a minimum of 8" remaining. Re-strip the fan lead wires 1/2" . Place remaining excess
wire into the ceiling electrical box. The bracket and fan must remain properly grounded.
This Remote Control Transmitter and Receiver is not compatible with Casablanca Hang Tru® Canopy Systems.
You may have installation issues if the fan is installed on an angled ceiling.
blue
black
white
M6009-01 • 04/17/14 • © Casablanca Fan Company
If you are installing multiple remote-controlled fans
on the same circuit breaker,
you may need to perform a few extra steps to prevent
interference or faulty operation of your remote controls.
Go to www.HunterFan.com/FAQs and click "How do I properly
install multiple remote-controlled fans?" for more information.
Receiver
Ceiling
Plate
OR
Receiver
Canopy
Canopy
black (ungrounded) black (live in)
white (grounded) white (neutral in)
CONNECT WIRES FROM RECEIVER TO WIRES FROM OUTLET BOX - Using an orange wire connector connect
the black wire (ungrounded) from the ceiling to the black wire from the receiver (marked "live in"). Connect
the white wire (grounded) from the ceiling to the white wire from the receiver (marked "neutral in").
AFTER ALL WIRES ARE CONNECTED and secured with wire connectors, re-install the canopy.
To avoid possible electrical shock, before installing or servicing your fan, disconnect
the power by turning off the circuit breakers to the outlet box and associated wall
switch location. If you cannot lock the circuit breakers in the off position, securely
fasten a prominent warning device, such as a tag, to the service panel.
www.CasablancaFanCo.com
1.888.227.2178
For low pro le fans, the receiver should
be secured to the ceiling bracket with a
cable tie.
Cable Tie
Ceiling
Bracket
OR
Receiver
Fan Body