Water Temperature Control - Kenmore 110.2942 Quick Start Manual

WATER TEMPERATURE CONTROL

• You should select the wash/rinse water temperature based on the type of load you are washing.
• Always use the warmest wash water safe for fabric and follow garment label instructions. For recommended use, see the Use
and Care Guide.
• Depending on location, water temperatures may vary by season. The fill rate may also differ depending on the water
temperature selected.
CYCLE SELECTOR (TIMER) CONTROL
Heavy Duty
Use this cycle for cottons and linens used regularly.
For maximum soil removal, you should set the Cycle
Selector (Timer) Control for the longest available time.
Normal / Casual
Select this cycle for synthetic fabrics such as dress shirts,
blouses, and slacks. The cycle will give you a load-cooling
spray rinse to reduce wrinkling.
Delicate
This cycle features brief periods of intermittent agitation
to clean lightly soiled items.
Before you call service...check for the following.
TROUBLESHOOTING – SOUNDS and LEAKS
Loud clicking and banging?
• The yellow shipping strap may still be in the rear of the
washer. Completely remove the yellow shipping strap.
• The washer should be level, and the feet should be firmly
on the floor.
Some sounds are normal but may be different from
those of your previous washer.
• The gears engaging after the drain and before the spin.
• The sound of air being pulled through the pump after most
of the water has drained.
© 2008 Sears Brands, LLC.
W10026671A
Is the washer leaking?
• Fill hose connections are tight
• Gaskets in fill hose are tight and flat
• Drain hose clamp is securely attached
• Faucets, drain/standpipe, or laundry tub is not leaking
• The washer tub is centered, and the load evenly balanced
at the start of each load
• The washer is level
• The front feet are installed, and the nuts are tightened
to the cabinet
See the Use and Care Guide for complete details.
Registered Trademark / Trademark /
® TM
Sears Brands, LLC, used under licensee by Sears Canada Inc.
Rinse & Spin
Select this option if you think an extra rinse is needed. Set
OPTIONS Control (if available) to One Rinse. You should then
set the Cycle Selector (Timer) Control knob to a Rinse setting.
Spin Only
A drain and spin may help shorten drying times for some fabrics
by removing excess water. Set OPTIONS Control (if available)
to One Rinse. You should then set Cycle Selector (Timer)
Control to a Spin setting.
Service Mark of
SM
7/08
Printed in U.S.A.