Sharp MZ-700 Basic Manual page 77

SeJ
I
78
Reference:
If, for file conversion, the source drive and destination drive are the same, the
following display is added.
Display:
1~1"""t source,
1.
Any key
a:!Il
or
~Q
• .\' [
I<.~t
dest i nat ion,
1.
An y key a:!Il
J
Explanation:
The above display occurs if the input of the destination file has ended. First, there will
be a display meaning "insert the source disk", and then, after the source disk is
inserted into the disk drive, press a key (any key). When the key input occurs, the
content of the source disk file is read into the memory of the MZ-700. When this
read-in is finished, there will be a display meaning "insert the destination disk". Take
out the source disk and insert the destination disk into the floppy disk drive in its
place. After insertion is completed, press a key (any key). When the key input occurs,
the data in the memory of the MZ-700 will be written into the destination disk.
Display when conversion finishes
:1:". •
Thf following display will be shown after the conversion finishes.
i/ ,..-,----
;: : I
**E.d
of
o
b
* *
j..
'~.,
..
~
. B're a ,
,
..
Convert " . i n [Y/N]
'iJ:
,:---
Explanation:
The "END OF JOB" message means that the conversion has finished. "BREAK"
means that there was an interruption
I
SHIFT
I
+
IBREAKI during the job.
"ERROR xx" means that there was an error during the job.