Advertisement
(2) . .
J""",tin, . .
the d!,,-,
iJ'l.;~~i$k
dri".,: "
. ' ... , . . • . ' ..•. ,'
' . Reachhe
notes on the
instructiOn
sheet
in
a
pft!l<ing
ease'.
Disk holder
1) Press the EJECT button to open the disk holder.
2) Insert the disk along the disk guides with the head window at the front.
(Hold the disk by the edge of its jacket.) Data can be read or written
on side A or side B. Check the side to be used - it is indicated on the
jacket.
3) Push the disk in lightly until it stops, then close the disk holder. Be sure
to insert the disk along the disk guides. Never close the disk holder unless
the disk is fully inserted.
(3) Write-protect tab
This tab is removed to prevent 'data on the disk from being deleted ac-
cidentally. When this tab is removed, no data can be saved to the disk,
although data can be read.
Some master disks are supplied by SHARP with their tabs already removed.
Sides A and B have one write protection tab each, so each side can be write
protected independently.
The write-protect tab is on the right side of the side of the disk it protects
(as shown in the figure on page 3).
Write.protect tab for side A
~
name ;nd;cat;on
- 4 -
Side name indication for side A
Recording surface A
1
J
,I
J
Advertisement
