Table of Contents
Advertisement
Care and Cleaning
2. CLEANING GRILL, TOP OVEN AND MAIN OVEN
OVEN
SHELVES
MAIN
OVEN
BASE
3. OVEN DOORS
CONTROL PANEL
TRIMS
28
(a) Base & Rear of Top Oven and Base of Main Oven.
Wipe out the oven with a damp soapy cloth. For more
stubborn stains on the base of the oven use a well
soaped fine steel wool soap pad.
GRILL
(b) Grill Pan & Oven Shelves.
PAN
BASE &
To prevent stains from being burnt on to the grill pan,
REAR
food support and rod shelf, always wash immediately
after use in warm soapy water.
Use a well soaped fine steel wool soap pad to remove
stubborn stains from the rod shelves, grill pan and the base of
the oven.
DO NOT use aerosol cleaners on this oven as they could
adversely affect the fan motor unit, and cannot be wiped off
the fan blade.
(a) Control Panel
Regularly wipe with a clean, damp cloth and polish with a clean,
dry cloth.
(b) Trims
It is advisable to clean the trims regularly to prevent any build up
of soiling which may detract from the appearance of the cooker.
The recommended method of cleaning is to wipe over the trims
with a clean, soft cloth wrung out in warm water, or mild non
abrasive cleaner. (If in doubt try the cleaner on a small area of
OVEN
trim which is not noticeable in normal use), then after wiping
DOORS
with a cloth wrung out in clear water, dry with a clean, soft cloth.
(c) Inner Door Panels & Glass
Open the door fully. The glass panel may now be washed.
Stubborn stains can be removed by using a well soaped, fine
steel wool soap pad.
(d) Stainless trims (UY46X only)
Regularly wipe with a clean, damp cloth and polish with a
clean dry cloth.
DO NOT use scouring pads, or abrasive powder, which will
scratch the glass.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the UY46 and is the answer not in the manual?
Questions and answers
Remove oven door
1. Switch off the appliance at the mains supply and allow it to cool.
2. Position the top or main oven door as shown in the manual's figure 1.
3. Wedge the door open using a towel to keep your hands free.
4. Grip the inner door panel and handle/outer glass assembly.
5. Remove the two screws and fibre washers, keeping them aside.
6. Pull the handle/outer glass assembly outward from the top while holding the inner door panel.
7. Unhook the handle/outer glass assembly at the bottom by lifting it upwards.
8. Take care not to dislodge the rubber grommets in the bottom of the door.
9. Return the inner door panel to the closed position carefully to avoid trapping fingers.
This answer is automatically generated