Failed Wired Connection - Samsung SMART TV E-Manual

31
IP Settings
From the
Gateway, and the
●
Use one of the two methods below to enter the numerical values.
Use the on-screen QWERTY keypad.
가상리모컨
Press the
IP Settings
IP Setting
IP Address
Subnet Mask
Gateway
DNS Setting
DNS Server
OK
41
The TV attempts to connect to the network again using the specified settings. A confirmation
message is then shown once a connection is established. Select

Failed Wired Connection

No network cable found
Make sure the network cable is plugged in. If it is connected, make sure the router is turned on. If it is
on, try turning if off and on again.
IP auto setting failed
Perform the following or set the IP address manually from
11
Ensure that the DHCP server is enabled on the router and reset the router.
21
If this does not work, contact your Internet Service Provider for more information.
Unable to connect to the network
Check the following:
11
IP Settings
Check the
21
Ensure that the DHCP server is enabled on the router and unplug and then plug the router back in.
31
If this does not work, contact your Internet Service Provider for more information.
IP Setting
screen, set
DNS Server values, and then select OK.
and use the keys on the number panel.
Enter manually
0.0.0.0
0.0.0.0
0.0.0.0
Enter manually
0.0.0.0
Cancel
Try Now Try Now
Try Now
Try Now
settings.
Enter manually, enter
to
IP Settings.
IP Address, Subnet
OK
to proceed.
Mask,