Fortinet FortiGate-80C Quick Start Manual

LED State
Green
Power
Off
Green Flashing
Status Green
Red
Green
Internal, DMZ,
WAN1, WAN2 Green Flashing
Off
HA Green
Red
Alarm Amber
Off
Visit these links for more information and documentation for your Fortinet product.
• Technical Documentation - http://docs.fortinet.com
• Fortinet Knowledge Center - http://kb.fortinet.com
• Fortinet Technical Support - http://support.fortinet.com
• Training Services - http://campus.training.fortinet.com
Package Contents
Interface Type Speed
Internal RJ-45 10/100 Base-T
WAN1 and RJ-45 10/100/1000
WAN2 Base-T
DMZ RJ-45 10/100 Base-T
Console RJ-45 9600 Bps
8/N/1
USB USB
Modem RJ-11
Express- Express-
Card slot Card/34,
Express-
Card/54
POWER STATUS
Power
LED
Status
Connecting
Before you begin
If using the wall-mount kit, remove the rubber feet before attaching the wall mount brack-
ets.
Connect the following to the FortiGate unit. Ensure the FortiGate unit is placed on a stable
surface.
• Insert a network cable to WAN1. Insert the other end to the router connected to the
Internet, or to the modem.
• Connect a network cable to the Internal port 1, 2, and 3.
• Insert the other end to a computer or switch.
• Connect the AC Power Cable to the Power Supply.
• Connect the Power Cord to a surge protected power bar or power supply.
• Insert the pointed end of the cable tie into the hole in the rear panel of the chassis to
anchor the cable tie to the chassis.
• Loop the loose end around the adapter cable and insert the loose end into the locking
latch.
• Pull the loose end to adjust the tightness of the loop around the adapter cable to pre-
vent cable from being accidentally pulled out the FortiGate unit.
Optional
Insert the ExpressCard (not supplied) into the ExpressCard 3G slot.
Configuration Tools
Web-based manager
The FortiGate web-based manager is an easy to use management tool.
Use it to configure the administrator password, the interface and default gateway addresses,
and the DNS server addresses.
Requirements:
• An Ethernet connection between the FortiGate unit and management computer.
• A web browser such as FireFox or Internet Explorer on the management computer.
Description
The FortiGate unit is on.
The FortiGate unit is off.
The FortiGate unit is starting up.
The FortiGate unit is running normally.
Modem is in use and connected.
The correct cable is in use and the connected
equipment has power.
Network activity at this interface.
No link established.
The FortiGate unit being used in an HA cluster.
A critical error has occurred.
A minor error has occurred.
No errors detected.
Protocol Description
Ethernet A 6-port switch connection for up to six devices or the
internal network.
Ethernet Redundant connections to the Internet.
Ethernet Optional connection to a DMZ network or to other
FortiGate-80C units for high availability (HA).
RS-232 Optional connection to the management computer. Pro-
vides access to the command line interface (CLI).
USB Two optional connections for the USB key, modem, or
backup operation.
Not enabled for this model.
The Universal ExpressCard slot adds wireless communica-
tions.
INTERNAL
1 3
5
HA ALARM WAN 1 WAN 2 DMZ
2 4 6
Internal
WAN
Interface
Interfaces
DMZ
LED
LED
QuickStart Guide
POWER STATUS
© Copyright 2010 Fortinet Incorporated. All rights reserved.
Products mentioned in this document are trademarks or registered trademarks
of their respective holders.
Regulatory Compliance
FCC Class B Part 15 CSA/CUS
4 July 2010
2 Mounting Brackets
Cable Tie
Power Supply
5
DC+12V CONSOLE USB
6
USB
Ground Power
Connection
Cable Tie
Internal Interface,
RJ-45 Serial
Mounting switch connectors
Connection
Hole
Power cable connects to power supply
Optional RS-232 serial cable connects to serial port on management computer
INTERNAL
5
DC+12V CONSOLE USB
6
Ethernet cables connect
Straight-through
to computers on internal network
Command Line Interface (CLI)
The CLI is a full-featured management tool. Use it to configure the administrator password,
the interface addresses, the default gateway address, and the DNS server addresses. To
configure advanced settings, see the Tools and Documentation CD included with the
FortiGate unit.
Requirements:
• The RJ-45 to DB9 serial connection between the FortiGate unit and management com-
puter.
• A terminal emulation application (HyperTerminal for Windows) on the management
computer.
INTERNAL
1 3 5
HA ALARM WAN 1 WAN 2 DMZ
2 4 6
01-412-89805-20090615
QuickStart Guide
POWER STATUS HA
Tools and Documenation
Copyright 2009 Fortinet Incorporated. All rights reserved.
Trademarks
Welcome | Bienvenue | Willkommen |
Straight-through
AC Power Cable Ethernet cable
INTERNAL
3 1
DMZ WAN 2 WAN 1 MODEM
4 2
DMZ
WAN1
WAN2 MODEM
(Not enabled
on this model)
1 to 6
3 1
DMZ WAN 2 WAN 1 MODEM
4 2
Straight-through Ethernet
cables connect to Internet
Optional connection to
DMZ network
FortiGate-80C
FortiGate-30B
INTERNAL
1 3 5
ALARM WAN 1 WAN 2 DMZ 2 4 6
| Bienvenido | Benvenuto
RJ-45 to
DB-9 Serial Cable