Advertisement
• Replacing the Battery
When the effective range decreases replace the
battery.
Use one button lithium cell battery CR2032.
1. Press the catch on the left side of the battery holder
inwards
CD
as you pull the battery holder out
®.
(Fig.2)
2. Load a new battery into the holder with the
+
and -
terminals correctly positioned and then push the
holder back into the remote control. (Fig.3)
• Remove any dirt or fingerprints from the battery
before inserting. Failure to do this may cause
corrosion or malfunction.
• Be sure to read the precautions included with the
battery.
• Keep the batteries out of reach of children. If
swallowed, contact a physician immediately.
• Specifications
Type:
Channel mode:
Transmission:
Operating range:
Battery:
Battery life:
Dimensions (W x H x D):
Weight:
Consists of infrared controller,
signal transmitter and signal
sensor in the camera body
Two-second delay release
By transmit button
Approx. 5 m/16.4
ft.
One button lithium cell battery
CR2032
Approx. 6,000 transmissions
64 x 34 x 6 mm
2.5
x
1.3
x
0.2 in.
8.1 g/0.28
oz (without battery)
2
• All data is based on Canon's Standard Test Method.
• Subject to change without notice.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Do not make any changes or modifications to the equipment
unless otherwise specified in the instructions. If such
changes or modifications should be made, you could be
required to stop operation of the equipment.
This equipment has been tested and found to comply with
the limits for a class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Consult the dealer or an experienced radiofTV technician
for help.
This digital apparatus does not exceed the Class B limits for
radio noise emissions from digital apparatus as set out in
the interference-causing equipment standard entitled ·'Digital
Apparatus", ICES-003 of the Industry Canada.
For CA, USA only
Included lithium battery contains Perchlorate Material -
special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate/ for
details.
CE:
The
C(
Mark is a Directive conformity mark of the
European Community (EC)
La marque
C(
est une marque conforme aux
directives de la Communaute Europeenne
Das
C(
-Zeichen entspricht den EG-Richtlinien
La marca
C(
es una marca directriz de conformidad
de la Comunidad Europea (CE)
Advertisement
