Cleaning The Boiler; Cleaning The Boiler With Brushes - Buderus Logano G115 WS US/CA Installation And Service Instructions Manual

8
Heating system servicing
8.3

Cleaning the boiler

The boiler can be cleaned with brushes and/or by a wet
method. Cleaning equipment is available as accessory.
Caution: Risk of burning by touching hot
boiler parts.
V Wear appropriate protective personal
safety equipment.
V Open burner door by removing the two hexagon bolts
on the sides.
8.3.1

Cleaning the boiler with brushes

V Note the position of the heat exchanger baffles for later.
V Remove the hot gas baffle plates from the hot gas pas-
sages.
V Clean the hot gas baffle plates with one of the two
cleaning brushes.
V Clean the hot gas passages by turning the round clean-
ing brush.
V Clean the combustion chamber with a flat brush.
Remove the debris from the combustion chamber, the
hot gas flues and the flue connection.
V Refit the heat exchanger baffles in their original posi-
tions.
V Check sealing rope on burner door. Replace damaged
or hardened gasket cord.
You can obtain suitable gasket cord from
your local Buderus sales office.
V Close burner door with the two hexagon bolts (approx.
90 inch-lbs). Tighten the hexagon bolts evenly.
36 Logano G115 WS US/CA - Technical specifications are subject to change without prior notice.
1
Fig. 37 After opening the burner door
1 Flue gas baffles in the heat exchanger
Fig. 38 Brushing out the hot gas flues
Fig. 39 Brushing out the combustion chamber
7 747 019 141-27.1RS
7 747 019 141-37.1RS
7 747 019 141-38.1RS