Check Bag Indicator; Changing Filter Bag; Replacing Filter Bag - Hoover WindTunnel User Manual

G
Where to buy
Filter bags may be purchased from
Authorized Hoover Dealers (Depot),
Leading Retailers, from Hoover Factory
Service Centers, or through The Hoover
Company on-line at www.hoover.com.
What to buy
To assure cleaning effectiveness, use
Genuine HOOVER@ Allergen
only
Filtration Type Y disposable filter
bags.
It is imperative that you use only gen-
uine HOOVER filter bags made
Hoover Company to assure your clean-
er operates at peak performance.
HOOVER bags can be identified by
these trademarks -

Check bag indicator

(some models only)
The indicator (I) will begin to show red as
the filter bag fills with dirt.
There are three conditions that will cause
the indicator to become completely red:
2. If very fine materials have been picked
up, clogging the bag pores; change the
bag.
3. If there is a blockage at the front of the
cleaner, in the hose, tools or at the bag
opening; remove the blockage (see
'Clearing blockages" section).

Changing filter bag

Disconnect cleaner from electrical
outlet.
Removing bag door
To change filter bag, grasp top of bag
door and pull door forward.
Remove door.
by
The
Familiarize yourself with these home
maintenance tasks as proper use and
care of your cleaner will ensure contin-
ued cleaning effectiveness.
Filter bag
When to replace
Check filter bag from time to time.
Change the filter bag when dirt reaches
the dotted line. If more dirt than this
accumulates, your cleaner will not oper-
ate effectively.
Note: All new carpet has loose fibers
which can fill the bag quickly while
vacuuming.
This type of debris does
not activate the "Check Bag" indicator,
available on some models.
So, if you are using the cleaner on
new carpet, be sure to change the fil-
ter bag often, even
if you have a
"Check Bag" indicator and it does not
show red.
CAUTION: Very fine materials, such
as face powder, cornstarch, fireplace
ashes or fireplace soot, may seal the
filter bag and may cause it to burst
even though it is only partially full of
dirt. When cleaner is used to remove
material of this nature, change filter
bag often.
Removing and installing filter
Grasp filter bag collar (A) and pull collar
tube (B).
from
Note: Do not clean out old filter
reuse. Discard used filter bag.
Hold new filter bag as shown. Align open-
ing in filter bag with (B).
Push (A) firmly onto (B).
Tuck in filter bag.
bag
and