Page 2
INTRODUCTION This premium installation kit is for 1995-2010 Ford/Lincoln/Mazda and Mercury Vehicles. Included are all the parts you need to mount your car stereo or CD player into your vehicle’s dash. Refer to the individual instruction in this manual to remove your vehicle’s factory radio and assemble the kit. PRELIMINARY READ THESE INSTRUCTIONS BEFORE BEGINNING CAUTION: DISCONNECT YOUR VEHICLE’S NEGATIVE BATTERY TERMINAL...
Page 3
MOUNTING THE AFTERMARKET STEREO DOUBLE DIN INSTALLATION (FIGURES 1-6*) *BEFORE BEGINNING: Refer to Factory Stereo Removal section (pgs. 6-8) to determine the proper kit configuration for your vehicle. 1. After removing specified tabs, snap mounting brackets to trim panel as shown. 2.
Page 4
FIGURE 4 7022 MOUNTING AFTERMARKET BRACKET DOUBLE-DIN STEREO 7021 MOUNTING BRACKET CUT AT SCORE LINE AND DISCARD SHADED PORTION (BOTH BRACKETS) CUT OFF AND DISCARD ALL SHADED TABS (BOTH BRACKETS) 7019 TRIM PANEL FIGURE 5 7022 MOUNTING AFTERMARKET BRACKET DOUBLE-DIN STEREO 7021 MOUNTING BRACKET CUT AT SCORE LINE AND...
DOUBLE DIN INSTALLATION (FIGURE 7*) *BEFORE BEGINNING: Refer to Factory Stereo Removal section (pgs. 6-8) to determine the proper kit configuration for your vehicle. NOTE: This installation requires dash bezel modification because of the nosepiece height of double-DIN stereos. Make note of this if you are working on a leased vehicle or if the original unit is to be re-installed at a future date.
Page 6
FACTORY STEREO REMOVAL 2009-2010 FORD ECONOLINE/E-SERIES VAN RADIO REMOVAL: 1. With panel removal tool, unclip panel below steering wheel column, unplug and remove. 2. Unscrew the steering wheel tilt handle. 3. Extract (3) Phillips head screws located on the bottom panel surrounding the steering wheel column and with panel removal tool unclip the bottom panel and remove.
Page 7
2006-10 FORD EXPLORER 2007-10 FORD EXPLORER SPORT TRAC 2006-10 MERCURY MOUNTAINEER RADIO REMOVAL: 1. Lift center console lid and extract (2) 7mm hex screws. 2. Using a panel removal tool, lift up to release bezel surrounding center shift. 3. Using a panel removal tool, unsnap radio dash bezel surrounding radio. 2009-10 FORD F-150 (WORK TRUCK MODEL ONLY) RADIO REMOVAL: 1.
Page 8
4. Use a panel removal tool to carefully unsnap and remove the entire radio-A/C control center dash bezel, unplug and remove. 5. Extract (2) 7mm hex screws from below stereo, unplug and remove stereo. SCOSCHE STEREO INSTALLATION COMPONENTS STEREO DASH KITS...
Need help?
Do you have a question about the FD3090 and is the answer not in the manual?
Questions and answers